Sharp FP-R65CX Operation Manual - Page 15

ENGLISH FRANÇAIS REMOTE CONTROL OPERATION Operations available with the Remote Control • AUTO • MANUAL • POLLEN • OFF TIMER • Lights ON/OFF Plasmacluster Ion mode selections • ION AUTO • CLEAN • ION CONTROL • ION OFF POWER ON/OFF Button • When you press the POWER ON/OFF Button, a short beep will sound and operation will start in AUTO Mode. • Unless unplug the power cord, the operation starts in the previous mode the unit was operated in. • To stop, press the POWER ON/OFF Button again. A long beep will sound and operation will stop. Auto (Fan Speed) Button The fan speed switches automatically depending on the amount of impurities in the air. Manual (Fan Speed) Button The fan speed can be switched among Silent, MEDIUM and MAX settings. LIGHTS ON/OFF Button Switches the Plasmacluster Indicator Light and CLEANSIGN Light either ON or OFF. Transmitter Off Timer Button The set time switches every time the button is pressed as shown below. 1 hour Cancel 4 hours • The indicator light shows the remaining time. • The unit will stop operation when the timer is up. Pollen Mode Operation Button See Page E-12 Plasmacluster Ion Mode Selections ION AUTO When pressed, the unit will switch between Clean Mode and the Ion Control Mode automatically depending on the amount of impurities in the air as detected by the dust and odour sensors. Clean Mode will operate for 1 minute when the Auto function is selected. (SENTINEL Operation Indicator light turns on.) CLEAN When pressed, the unit will constantly operate in the Clean Mode, in which the same numbers of positive and negative ions are discharged. The Plasmacluster Indicator Light is blue.(SENTINEL Operation Indicator light turns on.) ION CONTROL When pressed, the unit will constantly operate in Ion Control Mode. The Plasmacluster Ion Indicator Light is green. ION OFF The generation of ions will stop and the Plasmacluster Indicator Light will go out. E-13