Sharp HT-CN300BK Service Manual - Page 8
Adjustment
View all Sharp HT-CN300BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
HT-CN300 ADJUSTMENT TUNER SECTION fL: Low-range frequency fH: High-range frequency • AM IF/RF Signal generator: 400 Hz, 30%, AM modulated Test Stage AM IF Frequency Frequency Display 450 kHz 1,720 kHz Setting/ Instrument Adjusting Connection Parts T351 *1 AM Band - Coverage AM Tracking 990 kHz 530 kHz 990 kHz (fL): T306 *2 1.3 ± 0.1 V (fL): T302 *1 *1. Input: Antenna Output: TP302 *2. Input: Antenna Output: TP301 • FM IF Notes: 1: Description of the "FM IF Adjustment" is not carried on this Manual. It is because the IF coil in the FM front end section has been best adjusted in the factory so that its further adjustment is not needed at the field. When replacing the FM front end assembly, no adjustment is needed either. 2: The parts in the FM front end section are prepared in a complete unit, so you can't obtain each part individually. CNP301 AM/FM ANTENNA TUNER PWB T302 AM TRACKING fL FE301 8 R381 TP301 T306 R357 AM BAND COVERAGE fL TP302 AM IF VR351 T351 FM MUTE LEVEL OSD SECTION 1: Connect all cables. 2: Power ON 3: Video input (DVD IN or VIDEO 1-IN or VIDEO 2-IN) :NTSC Signal. 4: Adjust Vfc with rotated of TC432. Vfc range : 2.65 V - 2.75V (Chick with DC voltmeter, connect (+) of DC voltmeter to pin 26 of IC401, connect (-) of DC voltmeter to pin 2 of CNP431). Figure 8-1 TUNER ADJUSTMENT POINTS VIDEO PWB IC401 CNP431 R522 TC432 26 Vcf (2.65 V - 2.75 V) C453 GND Figure 8-2 OSD. ADJUSTMENT POINTS - 8 -