Sharp IG-CL15UW IG-CL15UW Operation Manual - Page 14
Specifications - review
View all Sharp IG-CL15UW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
SPECIFICATIONS Model Power Supply Fan Speed Power Consumption(W) Airflow Volume(CFM) Applicable Floor Area(sq.ft) * Ion Density(ions/cm3) *2 Cord Length(ft) Outer Dimensions(in.) Weight(lbs) IG-CL5U 20V,60Hz HIGH LOW 7 3 46(.3m3/min) 30(0.8m3/min) 6(5m2) 25,000 7,000 6.5(2.0m) 0/2(W)x6/8(D)x3(H) 7.3(3.3kg) * The applicable floor area for which an emitted airborne ion density of about 25,000 ions/cm3 can be measured at a point near the center of the room (at a height of about 1.2m from the floor), during operation at the HIGH mode when the main unit is placed near a wall. Louvers adjusted to their lowest tilt angle. *2 Ion count per cm3 blown into air at around the center of the room (at a height of about 1.2m from the floor) during operation at each airstream setting when the main unit is placed near the wall. Louvers adjusted to their lowest tilt angle. • The number of ions will vary according to the room conditions and operation mode. Standby Power In order to operate the electrical circuits while the power plug is inserted in the wall socket, this product consumes about 0.4W of standby power. For energy conservation, unplug the power cord when the unit is not in use. TROUBLESHOOTING Before calling for service, please review the TROUBLESHOOTING chart below. The problem may not be a unit malfunction. Problem WHAT TO DO The Plasmacluster Ion Generator does not work. • Make sure to insert the plug. • Attach filter properly. (See page E-11) Flashing (red) Flashing (orange) Flashing (blue) Lighting (orange) • It's time to replace Plasmacluster Ion Generating Unit. Replace with a new Plasmacluster Ion Generating Unit. (See page E-) • Plasmacluster Ions are not released. Dust may block the filter, clean the filter. (See page E-9) • Remove dust from the needle electrode. (See page E-0) If the lights are still flashing after cleaning filter, unplug and contact the store you purchased or Sharp service center. • Filter is getting dirty. Clean the filter. After cleaning the filter, press Filter Reset Button for 3 seconds. (See page E-9) Flashing (blue) • Confirm the Plasmacluster Ion Generating Unit is set in correct position. (See page E-) Flashing (red) Flashing (orange) • Failure Unplug the power cord and contact the store you purchased or Sharp service center. E-2