Sharp KB-3300JS Service Manual - Page 3
Warning To Service Personnel - range
View all Sharp KB-3300JS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
KB-3300JS KB-3300JK KB-3300JW WARNING TO SERVICE PERSONNEL Range units contain circuitry capable of producing very high voltage and current, contact with following parts may result in a severe, possibly fatal, electrical shock. (Example) High Voltage Capacitor, High Voltage Power Transformer, Magnetron, High Voltage Rectifier Assembly, High Voltage Harness, Heating Elements, etc.. Read the Service Manual carefully and follow all instructions. Before Servicing 1. Disconnect the power supply cord remove cabinet. 2. Open the drawer and keep it open. 3. Discharge high voltage capacitor. , and then WARNING: RISK OF ELECTRIC SHOCK. DISCHARGE THE HIGH-VOLTAGE CAPACITOR BEFORESERVICING. The high-voltage capacitor remains charged about 60 seconds after the oven has been switched off. Wait for 60 seconds and then short-circuit the connection of the highvoltage capacitor (that is the connecting lead of the highvoltage rectifier) against the chassis with the use of an insulated screwdriver. Whenever troubleshooting is performed the power supply must be disconnected. It may, in some cases, be necessary to connect the power supply after the outer case has been removed, in this event: 1. Disconnect the power supply cord, and then remove neccessary covers. 2. Open the drawer and keep it open. 3. Discharge high voltage capacitor. 4. Disconnect the leads to the primary of the power transformer. 5. Ensure that the leads remain isolated from other components and oven chassis by using insulation tape. 6. After that procedure, reconnect the power supply cord. When the testing is completed, 1. Disconnect the power supply cord, and then remove covers. 2. Open the drawer and keep it open. 3. Discharge high voltage capacitor. 4. Reconnect the leads to the primary of the power transformer. 5. Reinstall the covers. 6. Reconnect the power supply cord. 7. Run the unit and check all functions. After repairing 1. Reconnect all leads removed from components during testing. 2. Reinstall the covers. 3. Reconnect the power supply cord. 4. Run the oven and check all functions. Microwave ovens should not be operated empty. To test for the presence of microwave energy within a cavity, place a cup of cold water on the oven tray, close the drawer and set the power to HIGH and set the microwave timer for two (2) minutes. When the two minutes has elapsed (timer at zero) carefully check that the water is now hot. If the water remains cold carry out Before Servicing procedure and re-examine the connections to the component being tested. When all service work is completed and the oven is fully assembled, the microwave power output should be checked and a microwave leakage test should be carried out. 1