Sharp LC-32DV28UT LC-26DV28UT LC-32DV28UT Operation Manual - Page 21

Connecting to External Equipment ■ When using DVI-HDMI conversion cable (INPUT 4): Rear of the TV 6 3 DVI-HDMI conversion cable 2 1 DVI OUT AUDIO (Illustration is LC-26DV28UT.) Ø 3.5 mm stereo minijack cable NOTE • When using an DVI-HDMI conversion cable, you should make an analog audio connection. In this case, in addition to connecting an DVI-HDMI conversion cable to the INPUT 4 (HDMI1) terminal, connect an audio cable to the AUDIO PC/ HDMI terminal and set "HDMI1 Audio" to "DVI". (See page 28.) ■ When using analog RGB cable (INPUT 6): Analog RGB cable Rear of the TV (D-sub 15pin cable or VGA cable) 6 3 2 RGB AUDIO Ø 3.5 mm stereo minijack cable 1 (Illustration is LC-26DV28UT.) NOTE • When using an analog RGB cable, input the audio signal to the AUDIO PC/HDMI terminal of INPUT 6. Displaying an image from a PC To view an image from a PC, perform the following procedure. ① Select the Input 6 (PC) mode using INPUT on the remote control or the TV/DVD set. (See page 15.) ② Adjust the "Picture" items if the PC image does not come in clearly. (See page 28.) PC compatibility chart PC Resolution Horizontal Frequency Vertical Frequency VESA Standard 720 x 400 31.5 kHz 70 Hz - 31.5 kHz 60 Hz ○ VGA 640 x 480 37.9 kHz 72 Hz ○ 37.5 kHz 75 Hz ○ 35.1 kHz 56 Hz ○ 37.9 kHz 60 Hz ○ SVGA 800 x 600 PC 48.1 kHz 72 Hz ○ 46.9 kHz 75 Hz ○ 48.4 kHz 60 Hz ○ XGA 1,024 x 768 56.5 kHz 70 Hz ○ 60.0 kHz 75 Hz ○ 1,280 x 768 47.8 kHz 60 Hz ○ WXGA 1,360 x 768 47.7 kHz 60 Hz ○ 19