Sharp LC46SE94U LC-46SE94U LC-52SE94U LC-65SE94U Operation Manual - Page 14
Preparation, Using the Remote Control Unit, Cautions Regarding the Remote Control Unit, Antennas - picture
UPC - 074000370869
View all Sharp LC46SE94U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Preparation Using the Remote Control Unit Use the remote control unit by pointing it towards the remote control sensor on the TV. Objects between the remote control unit and the remote control sensor may prevent proper operation. Cautions Regarding the Remote Control Unit • Do not expose the remote control unit to shock. In addition, do not expose the remote control unit to liquids, and do not place in an area with high humidity. • Do not install or place the remote control unit in direct sunlight. The heat may cause deformation of the remote control unit. • The remote control unit may not work properly if the remote control sensor on the TV is in direct sunlight or strong lighting. In such cases, change the angle of the lighting or the TV, or operate the remote control unit closer to the remote control sensor. Antennas To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set. 1. A 75-ohm system is generally a round cable with an F-type connector that can easily be attached to a terminal without tools (commercially available). F-type connector 75-ohm coaxial cable (round) 2. A 300-ohm system is a flat "twin-lead" cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter (commercially available). NOTICE F-type connector should be fingertightened only. When connecting the RF cable to the TV set, do not tighten the F-type connector with tools. If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.) F-type connector 300-ohm twin-lead cable (flat) 75-ohm coaxial cable Connecting Antenna Cable 1 Cable without a CATV converter Cable TV lead-In 2 VHF/UHF antenna 3 Combination VHF/ UHF antenna 75-ohm coaxial cable (round) Home antenna terminal (75-ohm) Coaxial cable (commercially available) Home antenna terminal (75-ohm) Coaxial cable (commercially available) • Connect the antenna cable to the TV using one of the methods in the illustration as shown (1, 2, 3 or 4). 4 Separate VHF/UHF antenna or 75-ohm coaxial cable (round) 300-ohm twin-lead cable (flat) VHF UHF ANTENNA ANTENNA 300-ohm twin-lead cable 300-ohm twin-lead cable Combiner (commercially available) IN OUT or 75-ohm coaxial cable 300/75-ohm adapter (commercially available) To TV antenna terminal 12