Sharp MX-3100N MX-2600N MX-3100N Operation Manual - Page 761
Removing Staple Jams
View all Sharp MX-3100N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 761 highlights
TROUBLESHOOTING REMOVING STAPLE JAMS Follow the steps below to remove a staple jam. ☞ FINISHER ☞ SADDLE STITCH FINISHER (page 8-9) FINISHER Open the cover. 1 While pressing the lever over to the left, slide the finisher to the left until it stops. 2 Gently slide the finisher until it stops. Lower the staple case release lever and remove the staple case. 3 Pull the staple case out to the right. Raise the lever at the front end of the staple case and remove the jammed staple. Remove the leading staple if it is bent. If bent staples remain, a 4 staple jam will occur again. Take care that a bent staple does not hurt you. 8-7 Contents
8-7
TROUBLESHOOTING
Contents
Follow the steps below to remove a staple jam.
☞
FINISHER
☞
SADDLE STITCH FINISHER
(page 8-9)
FINISHER
REMOVING STAPLE JAMS
1
Open the cover.
2
While pressing the lever over to the left,
slide the finisher to the left until it stops.
Gently slide the finisher until it stops.
3
Lower the staple case release lever and
remove the staple case.
Pull the staple case out to the right.
4
Raise the lever at the front end of the
staple case and remove the jammed
staple.
Remove the leading staple if it is bent. If bent staples remain, a
staple jam will occur again.
Take care that a bent staple does not hurt you.