Sharp MX-450U MX-M350U MX-M450U MX-M350N MX-M450N Operation Manual - Page 216

GENERAL SETTINGS PING command This setting is used to check if the machine and a computer connected to the network can communicate. Enter the IP address of the computer that you wish to check and touch the [START] key. A message will appear indicating whether or not there was a response from the computer. Security settings The following settings are related to security. Touch the [SECURITY SETTINGS] key to configure the settings. When any of these settings are changed, you must exit the administrator settings, turn off the main switch, wait a brief interval, and then turn the main switch back on to make the new settings take effect. SSL setting SSL can be used for data transmission over a network. SSL is a protocol that enables the encryption of information communicated over a network. Encrypting data makes it possible to transmit and receive sensitive information safely. Server port ● HTTPS: ● IPP-SSL: Apply SSL encryption to HTTP communication. Apply SSL encryption to IPP communication. Client port ● FTPS: Apply SSL encryption to FTP communication. ● SMTP-SSL: Apply SSL encryption to SMTP communication. ● POP3-SSL: Apply SSL encryption to POP3 communication. Level of encryption The encryption strength can be set to one of 3 levels. Enable IPsec IPsec can be used for data transmission/reception on a network. When IPsec is used, data can be sent and received safely without the need to configure settings for IP packet encryption in a Web browser or other higher-level application. This setting is only used to enable or disable IPsec; detailed IPsec settings are configured in the Web pages. Some Web page settings may not allow connection to the machine, or the settings may not allow printing, scanning, or Web page display. In this case, deselect [ENABLE IPsec] in this screen and change the Web page settings. SYSTEM SETTINGS SECURITY SETTINGS OK SSL SETTINGS ENABLE IPsec List print This setting is used to print lists and reports that can only be printed from the administrator settings. • Touch the [ADMINISTRATOR SETTINGS LIST] key to print one of the following groups: Copy, printer, fax/image send, document filing, general, security, all administrator settings lists • Touch a key other than the [ADMINISTRATOR SETTINGS LIST] key to begin printing a list or report. Sharp OSA settings The following settings are related to Sharp OSA. Touch the [Sharp OSA SETTINGS] key to configure the settings. ● Default display setting ● External account setting Default display setting The default screen that appears when the [DOCUMENT FILING] key is pressed can be specified. Select either the base screen of document filing mode or the external application selection screen. This setting can only be configured when the application communication module is installed. The setting also appears in the document filing settings. When the [CA] key ([Clear all] key) is pressed in document filing mode or Sharp OSA mode, the initial screen of the mode appears, regardless of the default display setting. External account setting When [ENABLE EXTERNAL ACCOUNT CONTROL] is enabled, the machine enters external count mode. When both [ENABLE EXTERNAL ACCOUNT CONTROL] and [ENABLE AUTHENTICATION BY EXTERNAL SERVER] are enabled, the machine enters external authentication mode. This item can only be selected when the external account module is installed. Change admin password This setting is used to change the administrator password that must be entered to configure the administrator settings. When the machine is first used, the administrator should change the administrator password that was set at the factory to the desired 5-digit code. Only one administrator password can be set. The factory default setting for the administrator password is 00000. 14