Sharp MX-M1100 MX-M850 MX-M950 MX-M1100 Operation Manual Suite - Page 619
IP Address Setting, Enable TCP/IP, Enable NetWare, IP Address, IP Subnet Mask, IP Gateway
View all Sharp MX-M1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 619 highlights
Network Settings Network settings are described below. Touch the [Network Settings] key to configure the settings. When any of these settings are changed, you must exit the system settings, turn off the [POWER] key ( interval, and then turn the [POWER] key ( ) back on to make the new settings take effect. ), wait a brief IP Address Setting When using the machine on a TCP/IP (IPv4) network, use this setting to configure the IP address of the machine. The settings are shown below. IP Address Enter the IP address of the machine. IP Subnet Mask Entry the IP Subnet Mask. IP Gateway Enter the IP Gateway address. DHCP Use this setting to have the IP address obtained automatically using DHCP (Dynamic Host Configuration Protocol). When this setting is enabled, it is not necessary to manually enter an IP address. • If the machine will be used on a TCP/IP network, be sure to enable "Enable TCP/IP" below. • If DHCP is used, the IP address assigned to the machine may change automatically. If the IP address changes, printing will not be possible. Enable TCP/IP To use the machine on a TCP/IP network, this setting must be enabled. Enable NetWare To use the machine on a NetWare network, this setting must be enabled. 49