Sharp MX-M450NA Administration Guide - Page 16

GENERAL SETTINGS Tandem setting This setting is used to configure the IP address and port number of the client printer when you wish to have two machines (which are used as TCP/IP network printers) print in tandem. The factory default setting for the port number is [50001]. Unless you experience difficulty with this setting, it does not need to be changed. The tandem function can also be prohibited, or the reception of tandem data from the other machine can be prohibited. (Normally this is not necessary.) To prohibit the tandem function, select "DISABLING OF MASTER MACHINE MODE". To prohibit reception of tandem data from the other machine, select "DISABLING OF SLAVE MACHINE MODE". NOTE To use the tandem function when auditing mode is enabled, the same account number must be entered on both machines. If the same account number is not entered, only the server machine may print or the printed pages may not be added to the correct account. PING command This setting is used to check if the machine and a computer connected to the network can communicate. Enter the IP address of the computer that you wish to check and touch the [START] key. A message will appear indicating whether or not there was a response from the computer. Security settings The following settings are related to security. Touch the [SECURITY SETTINGS] key to configure the settings. SSL setting SSL can be used for data transmission over a network. SSL is a protocol that enables the encryption of information communicated over a network. Encrypting data makes it possible to transmit and receive sensitive information safely. • HTTPS: Apply SSL encryption to HTTP communication. • IPP-SSL: Apply SSL encryption to IPP communication. List print This setting is used to print lists and reports that can only be printed from the administrator settings. • Touch the [ADMINISTRATOR SETTINGS LIST] key to print one of the following groups: Copy, printer, fax/image send, document filing, general, security, all administrator settings lists • Touch a key other than the [ADMINISTRATOR SETTINGS LIST] key to begin printing a list or report. 14 Sharp OSA settings The following settings are related to Sharp OSA. Touch the [Sharp OSA SETTINGS] key to configure the settings. Default display setting External account setting Default display setting The default screen that appears when the [DOCUMENT FILING] key is pressed can be specified. Select either the base screen of document filing mode or the external application selection screen. This setting can only be configured when the application communication module is installed. The setting also appears in the document filing settings. When the [CA] key ([Clear all] key) is pressed in document filing mode or Sharp OSA mode, the initial screen of the mode appears, regardless of the default display setting. External account setting When [ENABLE EXTERNAL ACCOUNT CONTROL] is enabled, the machine enters external count mode. When both [ENABLE EXTERNAL ACCOUNT CONTROL] and [ENABLE AUTHENTICATION BY EXTERNAL SERVER] are enabled, the machine enters external authentication mode. This item can only be selected when the external account module is installed. Change admin password This setting is used to change the administrator password that must be entered to configure the administrator settings. When the machine is first used, the administrator should change the administrator password that was set at the factory to the desired 5-digit code. Only one administrator password can be set. The factory default setting for the administrator password is 00000. Product key Use these settings to enter the product keys for the following options. PS3 expansion kit This setting is used to enter the product key for the PS3 expansion kit (this allows the machine to be used as a PostScript compatible printer). Ask your dealer for the product key. Network scanner expansion kit This setting is used to enter the product key for the network scanner expansion kit. Ask your dealer for the product key.