Sharp MX-M453N MXM363N|MXM453N|MXM503N Operation Manual - Page 789
Transmission takes a, long time., A destination is, pre-selected., Cannot write to USB, memory.,
View all Sharp MX-M453N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 789 highlights
TROUBLESHOOTING Problem Transmission takes a long time. A destination is pre-selected. Cannot write to USB memory. (When using USB Memory Scan.) Point to check Is the resolution setting appropriate at the time of scanning? Is "Default Address Setting" enabled in the system settings (administrator)? Is the connected USB device recognized correctly? Solution To select resolution and data compression settings that are suited to the purpose of transmission and create image data that is balanced in terms of resolution and file size, pay attention to the following points: Resolution settings The default resolution setting is [200X200dpi] in scanner and USB memory mode, and [200X100dpi] in Internet fax mode. If the original does not contain a halftone image such as a photo or illustration, scanning at the default resolution will create a practical and useful image. A higher resolution setting or the "Half Tone" setting (in Internet fax mode) should only be selected if the original contains a photo and you wish to give priority to the quality of the photo image. Exercise caution in this case as a larger file will be created than when the default setting is used. If you wish to send to a destination other than the default destination, touch the [Cancel] key. If you are the administrator and wish to change or disable the default destination, change the settings as appropriate in "Default Address Setting". ➞ System Settings (Administrator) > "Image Send Settings" > "Scan Settings" > "Default Address Setting" Use "USB-Device Check" in the system settings to check whether or not the device can be recognized. ➞ System Settings > "USB-Device Check" If it is not recognized, connect it once again. 8-31 Contents