Sharp MX-M753 MX-M623 MX-M753 Operation Manual - Page 870

TROUBLESHOOTING Problem The paper misfeeds. Paper does not feed from the paper tray. The image on paper is skewed. The automatic document feeder does not operate. Output does not collect neatly in the output tray of the finisher. Stapled output does not collect neatly. Point to check Is 5-1/2" x 8-1/2" (A5) size paper loaded? Has the correct paper size been set? Did you add paper to the bypass tray? Is the paper loaded correctly in the paper tray? In the Paper Tray Settings of the system settings, are restrictions placed on the trays that can be used in each mode (copy, print, fax, Internet fax, and document filing)? Is too much paper loaded in the bypass tray? Are the bypass tray guides adjusted to the width of the paper? Are the original guides adjusted to the width of the paper? Have functions been disabled by the administrator? Is the paper curled? Is the paper curled? Solution Load paper in tray 3 (the second tray) or in the bypass tray. 5-1/2" x 8-1/2" (A5) size paper cannot be used in other trays. When loading 5-1/2" x 8-1/2" (A5) size paper, place the paper in the horizontal (5-1/2" x 8-1/2"R (A5R)) orientation. If you are using a special size, be sure to specify the paper size. If the size of paper loaded in a tray was changed, be sure to check the paper size setting. ➞ System Settings > "Paper Tray Settings" > "Tray Settings" When adding paper, remove any paper remaining in the bypass tray, combine it with the paper to be added, and reload as a single stack. If paper is added without removing the remaining paper, a misfeed may result. Set the guides to the size of the paper. Make sure the height of the paper does not exceed the indicator line. Check the Paper Tray Settings and see if checkmarks appear in the checkboxes of each mode (Feeding Approved Job). Functions without a checkmark cannot be used for printing using that tray. ➞ System Settings > "Paper Tray Settings" > "Tray Settings" > "Change" > (Each mode) Do not load more than the maximum number of sheets. The maximum number of sheets varies depending on the paper type setting. For more information, see "SPECIFICATIONS" in the Safety Guide. Adjust the bypass tray guides to the width of the paper. Adjust the original guides to the width of the paper. Check with your administrator. Some functions may have been disabled in the system settings (administrator). It may help to turn the paper over in the paper tray. It may help to turn the paper over in the paper tray. 8-51 Contents