Sharp P100 UX-P100 Operation Manual - Page 27

Setting Up and Using OpenLCR 2. Setting Up OpenLCR 3 If the display shows the alternating messages at right, press the number keys to enter your fax/phone number, including the area code (the number must be 10 digits long). When finished, press START/MEMORY . (If the message at right doesn't appear, this step is not necessary.) SET OWN NUMBER 10 DIGITS Important! Be sure that you enter your correct area code and fax number. If not, your fax may not dial the correct number to connect to OpenLCR. 4 Follow the instructions you hear. ♦ If you are on a pulse dial line, press before pressing the number keys to respond. (This makes your fax temporarily issue tone signals when you press the number keys.) ♦ When registration is completed, your fax machine will receive the rate data from OpenLCR. This will last one or two minutes. When downloading is completed, the display will briefly show DOWNLOAD OK!! and then revert to the date and time. ♦ OpenLCR will also program the date and time and your fax number in your fax machine. Registering through OpenLCR's Web site You can also register at OpenLCR's Web site, www.OpenLCR.com. After registering you will need to receive the rate data manually (service is not activated until your fax receives the rate data). See Downloading (receiving) the rate data manually on the following page. If you move, you must re-register! The rate data that you receive is based on the address you provide when registering with OpenLCR. If you move, the rate data will not be correct for your new location. In this case, repeat the registration procedure to give OpenLCR your new address. 25