Sharp PN-455 PN-455 Operation Manual - Page 22
Mounting the Temporary Stands, Bundling Cables
View all Sharp PN-455 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Mounting the Temporary Stands Please note that the temporary stands are for temporary use only until the monitor is properly mounted. Attach each temporary stand to the bottom of the monitor as shown below. ▼ Rear view Screw Temporary stand Bundling Cables The AC cord can be fastened using the supplied AC cord clamp. This will prevent the AC cord from falling off. Also, the cables connected to the terminals on the back of the monitor from the external equipment can be neatly bundled using the supplied cable clamps as shown in the illustration below. This will prevent stray or disorganized cables at the back of the monitor. ▼ Rear view 1 Fastened part 2 Band 3 Hole for the AC cord clamp Fastening the AC cord 1. Attach the supplied AC cord clamp to the AC cord, making sure the AC cord clamp is circular hole-side down. 2. Insert the tip of the band into the hole for the AC cord clamp. 3. While holding the tail of the band, slide the fastened part toward the AC input terminal. E 22