Sharp PN-C861H PN-C751H PN-C861H Setup Manual - Page 12

Specifications Model Power requirement Operating temperature *1 *2 Operating humidity *2 Power consumption *3 Dimensions inch (mm) (excluding protrusions) Weight lbs. (kg) PN-C861H PN-C751H AC 100 - 240 V, 5.9 A, 50/60 Hz AC 100 - 240 V, 5.2 A, 50/60 Hz 41°F to 95°F (5°C to 35°C) 20% to 80% (no condensation) 530 W 460 W Approx. 78-1/4 (W) x 4-7/16 (D) x 46-1/4 (H) Approx. 68-5/16 (W) x 4-1/8 (D) x (1988 x 113 x 1175) 40-13/16 (H) (1735 x 105 x 1036) Approx. 176.4 (80) Approx. 134.5 (61) *1 Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases, please check the temperature condition specified by the optional equipments. *2 In addition, check the requirements of the computer and other devices to be connected, and make sure that all requirements are satisfied. *3 When an option is installed in the expansion slot. When an option is not installed, PN-C861H: 420 W, PN-C751H: 360 W. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Mounting Precautions (For SHARP dealers and service engineers) • When installing, removing or moving the monitor, ensure that this is carried out by at least 4 people. • Be sure to use a wall-mount bracket designed or designated for mounting the monitor. • This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials such as plaster / thin plastic board / wood before starting installation. • This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight of the monitor. Install by the most suitable method for the material and the structure. • To attach a VESA-compliant mounting bracket, use M8 screws that are 3/8 inch (10 mm) to 1/2 inch (12 mm) longer than the thickness of the mounting bracket. 3/8 - 1/2 inch (10-12 mm) Screws (M8) Mounting bracket Monitor mounting • Do not use an impact driver. • When moving the monitor, be sure to hold the handles or the parts marked by This may cause product damage, failure, or injury. below. Do not grasp the screen or tray. [PN-C861H] [PN-C751H] • If you need to temporarily place the monitor on a table or other surface during installation, spread a thick soft cloth on the table to prevent damage to the screen and table. • Prior to repacking or removal, remove the tray. • After mounting, please carefully ensure the monitor is secure, and not able to come loose from the wall or mount. • Do not use any screw holes other than those for mounting brackets, located on the rear of the monitor, for installation. E 12