Sharp PN-L802B PN-L802B Quick Start Guide - Page 7

ENGLISH Supplied Components If any component should be missing, please contact your dealer.  Liquid Crystal Display Monitor: 1  Remote control unit: 1  Cable clamp: 3  Power cord: 1  R-6 battery ("AA" size): 2  CD-ROM (Utility Disk for Windows): 1  Setup Manual (this manual): 1  Touch pen: 1  Pen tip (for touch pen): 2  Touch pen battery (LR-03 ("AAA" size)): 1  USB cable: 1  Eraser: 1  Tray: 1  Tray mounting bracket: 2  Tray mounting screws: M5 long x 4 / M5 short x 2 / M4 x 2  Cover: 2  Cover screws (M4 with washers): 4  Cover seal: 2  T erminal label: 1 Used when installing the expansion board PN-ZB01 (optional).  C over Sharp logo: 1 Place this sticker onto the SHARP logo to cover the logo. * Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission. * For environmental protection! Do not dispose of batteries in household waste. Follow the disposal instructions for your area. Specifications Model Power requirement Operating temperature * Operating humidity Power consumption (Maximum) Dimensions (excluding protrusions) Weight PN-L802B AC 100 V - 240 V, 2.9 A, 50/60 Hz 41°F to 95°F (5°C to 35°C) 20% to 80% (no condensation) 255 W [When PN-ZB01 (optional) is attached: 260 W] inch (mm) Approx. 74 (W) x 5-5/16 (D) x 45-9/16 (H) (1880 x 135 x 1157) lbs. (kg) Approx. 224.9 (102) (excluding the temporary stand) [PN-ZB01 (optional): Approx. 1.102 (0.5)] * Temperature condition may change when using the monitor together with the optional equipments recommended by SHARP. In such cases, please check the temperature condition specified by the optional equipments. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Preparing the Remote Control Unit and the Touch Pen Installing the batteries 1. Press the cover gently and slide it in the direction of the arrow. Inserting the battery 1. Rotate the battery cap and remove it, and then pull out the cover. Battery cap 2. See the instructions in the compartment and put in the supplied batteries (R-6 ("AA" size) x 2) with their plus (+) and minus (-) sides oriented correctly. 3. Close the cover. 2. Insert the supplied battery (LR-03 ("AAA" size)) in the orientation shown, and attach the cover and battery cap. 5E