Sharp R-1880LST R-1870 , R- 1871 , R-1872 , R-1874 Installation Instructions - Page 4
Preparation Of The Oven, Ventilation System - microwave
View all Sharp R-1880LST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
8 PREPARATION OF THE OVEN 1. Rest the oven on its side as shown in Figure 7. Place portion (C) of the carton underneath to protect the outercase from being damaged. 2. Remove the two screws which secure the mounting plate to the rear side of the oven. Remove the mounting plate. The two screws can be discarded. NOTE: If the unit you purchased does not have the mounting plate attached to the rear side of the oven, please disregard this section and continue to Section 9. Figure 7 9 VENTILATION SYSTEM This Microwave Oven/Hood System is designed for adaptation to three types of hood ventilation systems. Select the type required for your installation. A. RECIRCULATING - Non-Vented, Ductless Operation The unit is shipped assembled for recirculating. NOTE: 1. The Exhaust Damper Assembly is not required for recirculating operation. 2. The Charcoal Filter should be replaced every 6 to 12 months, depending on use. 3. The Charcoal Filter RK-220 is also sold as an accessory. See Operation Manual for ordering information. B. HORIZONTAL EXHAUST - Outside Ventilation 1. Remove and save the 4 screws from Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket, as shown in Figure 8. 2. Lift Hood Fan Unit carefully and slip wires out of cavity. See Figure 9. CAUTION: Do not pull or stretch hood fan wiring. 3. Rotate the Hood Fan Unit 180˚ so that the fan blade openings are facing the back of the oven. Note, you will need to lift the wire over the hood fan unit so the wire will clear. See Figure 10 (A). Replace Hood Fan Unit into the oven. Be careful not to pinch the wire and the Hood Fan Unit. See Figure 10 (B). 4. Put the wire back into the cavity. 5. Replace the fan cover bracket. Make sure the fan blades are visible through the rear openings in oven before proceeding. Attach the fan cover bracket to the unit with the 4 screws removed in step 1 above. See Figure 11. The hood fan is now rotated for horizontal exhaust operation. 6. Attach the Exhaust Damper Assembly to the back of the mounting plate by sliding it into the slits in the same direction as the arrow. See Figure 12. Using tapping screw 4 x 12 mm from the INSTALLATION HARDWARE, tighten into place. Mounting plate Grease filter openings Fan Cover Bracket Figure 8 Figure 9 (A) Rotate 180˚ (B) Figure 10 4