Sharp R-307KW Service Manual - Page 8

Sharp R-307KW Manual

Get Sharp R-307KW PDF manuals and user guides View all Sharp R-307KW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

R307KW RC30H7KAWPTER 5. GENERAL INFORMATION Service Manual [1] GROUNDING INSTRUCTIONS This oven is equipped with a three prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accordance with the National Electrical Code and local codes and ordinances. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. WARNING: Improper use of the grounding plug can result in a risk of electric shock. Electrical Requirements The electrical requirements are a 120 volt 60 Hz, AC only, 15 or 20 amp. fused electrical supply. It is recommended that a separate circuit serving only this appliance be provided. When installing this appliance, observe all applicable codes and ordinances. A short power-supply cord is provided to reduce risks of becoming entangled in or tripping over a longer cord. Where a two-pronged wallreceptacle is encountered, it is the personal responsibility and obligation of the customer to contact a qualified electrician and have it replaced with a properly grounded three-pronged wall receptacle or have a grounding adapter properly grounded and polarized. If the extension cord must be used, it should be a 3-wire, 15 amp. or higher rated cord. Do not drape over a countertop or table where it can be pulled on by children or tripped over accidentally. CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND GROUNDING PRONG FROM THIS PLUG. Grounded Receptacle Box 3-Pronged Plug Grounding Pin 3-Pronged Receptacle [2] OVEN DIAGRAM 1. OVEN 1. Door opening button 5 Push to open door. 2. Oven door with see-through window 13 14 3. Safety door latches The oven will not operate unless 4 6 12 the door is securely closed. 4. Door hinges 1 5. Door seals and sealing surfaces 6. Turntable motor shaft 3 2 7. Removable turntable support 8 11 10 3 7 Carefully place the turntable sup- 9 port in the center of the oven floor. 8. Removable turntable Place the turntable securely on the turntable support securely. The turntable will rotate clockwise or counterclockwise. Only remove for cleaning. 9. Ventilation openings (Rear) 10.Oven light It will light when oven is operating or when the door is open. 11.Waveguide cover: DO NOT REMOVE. 12.Auto-Touch control panel 13.Time display: 99 minutes, 99 seconds 14.Power supply cord 5 - 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
R307KW
5 – 1
R307KW
Service Manual
CHAPTER 5.
GENERAL INFORMATION
[1] GROUNDING INSTRUCTIONS
This oven is equipped with a three prong grounding plug. It must be plugged into a wall receptacle that is properly installed and grounded in accor-
dance with the National Electrical Code and local codes and ordinances.
In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current.
WARNING:
Improper use of the grounding plug can result in a risk of electric shock.
Electrical Requirements
The electrical requirements are a 120 volt 60 Hz, AC only, 15 or 20 amp. fused electrical supply. It
is recommended that a separate circuit serving only this appliance be provided. When installing
this appliance, observe all applicable codes and ordinances. A short power-supply cord is provided
to reduce risks of becoming entangled in or tripping over a longer cord. Where a two-pronged wall-
receptacle is encountered, it is the personal responsibility and obligation of the customer to contact
a qualified electrician and have it replaced with a properly grounded three-pronged wall receptacle
or have a grounding adapter properly grounded and polarized. If the extension cord must be used,
it should be a 3-wire, 15 amp. or higher rated cord. Do not drape over a countertop or table where
it can be pulled on by children or tripped over accidentally.
CAUTION: DO NOT UNDER ANY CIRCUMSTANCES CUT OR REMOVE THE ROUND
GROUNDING PRONG FROM THIS PLUG.
[2] OVEN DIAGRAM
1. OVEN
1.
Door opening button
Push to open door.
2. Oven door with see-through win-
dow
3.
Safety door latches
The oven will not operate unless
the door is securely closed.
4.
Door hinges
5.
Door seals and sealing surfaces
6.
Turntable motor shaft
7.
Removable turntable support
Carefully place the turntable sup-
port in the center of the oven floor.
8.
Removable turntable
Place the turntable securely on the turntable support securely. The turntable will rotate clockwise or counterclockwise. Only remove for cleaning.
9.
Ventilation openings (Rear)
10.Oven light
It will light when oven is operating or when the door is open.
11.Waveguide cover: DO NOT REMOVE.
12.Auto-Touch control panel
13.Time display: 99 minutes, 99 seconds
14.Power supply cord
3-Pronged
Plug
Grounded
Receptacle Box
Grounding Pin
3-Pronged Receptacle
14
8
9
7
12
13
1
5
3
2
4
6
11
3
10