Sharp R420 R-420 Microwave Operation Manual - Page 17

Compu Defrost, Compu Defrost Chart

Page 17 highlights

SPECIAL FEATURES COMPU DEFROST CompuDefrost automatically defrosts all the foods shown in the CompuDefrost Chart below. Round the weight to the nearest half pound. (Ex: if the steak's actual weight is 2.2 lb round to 2.0 lb If the steak's weight is 2.4 lb round to 2.5 lb.) To enter weight, touch the desired COMPU DEFROST pad for a 0.5 lb increase per touch. (Ex: touch four times for 2.0 lb.) • Suppose you want to defrost a 2.0 pound steak . PROCEDURE DISPLAY STEAKS/ 1 CHOPS x 4 2.0 LBS DEF HELP Quickly touch STEAK/CHOPS pad 4 times for 2.0 lb. The oven will start automatically. The oven will stop and directions will be displayed. Follow the indicated message. After the 1st stage, open the door, turn steak 2 over and shield any warm portions. Close the door. START Touch START pad. After the 2nd stage, open the door and shield 3 any warm portions. Close the door. START Touch START pad. 4 After defrost cycle ends, cover and let stand as indicated in chart below. NOTE: 1. If you attempt to enter more or less than the allowed weight as indicated in chart below, ERROR will appear in the display. 2. CompuDefrost can be programmed with More or Less Time Adjustment. Touch the POWER LEVEL pad once or twice after selecting the weight. See page 16. 3. To defrost other foods or foods above or below the weights allowed on CompuDefrost Chart. Use time and 30% power. See Manual Defrost on page 16. 4. You may choose to enter the weight in tenths of pounds. This procedure may be easier with larger weights such as 4 pounds because it requires fewer touches. To program, touch desired COMPU DEFROST pad and enter weight by touching the number pads. Ex: touch STEAKS/CHOPS then 4 and 0 for a weight of four pounds or touch STEAKS/ CHOPS then 2 and 2 for a weight of 2.2 lb. 5. To use any CompuDefrost pad, touch within 1 minute after cooking, opening and closing the door or touching the STOP/CLEAR pad. COMPU DEFROST CHART FOOD Ground Meat AMOUNT .5 - 3.0 lb PROCEDURE Remove any thawed pieces after each stage. Let stand, covered, for 5 to 10 minutes. Steaks/Chops (Fish) .5 - 4.0 lb After each stage, rearrange and if there are warm or thawed portions, shield with small flat pieces of aluminum foil. Remove any meat or fish that is nearly defrosted. Let stand, covered, for 10 to 20 minutes. Chicken Pieces .5 - 3.0 lb After each stage, if there are warm or thawed portions, rearrange or remove. Let stand, covered, for 10 to 20 minutes. NOTE: Check foods when oven signals. After final stage, small sections may still be icy. Let stand to continue thawing. Do not defrost until all ice crystals are thawed. Shielding prevents cooking from occurring before the center of the food is defrosted. Use small smooth strips of aluminum foil to cover edges and thinner sections of the food. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

15
SPECIAL FEATURES
CompuDefrost automatically defrosts all the foods
shown in the CompuDefrost Chart below.
Round the weight to the nearest half pound. (Ex: if the
steak’s actual weight is 2.2 lb round to 2.0 lb If the
steak’s weight is 2.4 lb round to 2.5 lb.)
To enter weight, touch the desired
COMPU DEFROST
pad for a 0.5 lb increase per touch. (Ex: touch four
times for 2.0 lb.)
Suppose you want to defrost a 2.0 pound steak .
COMPU DEFROST
NOTE:
1.
If you attempt to enter more or less than the allowed
weight as indicated in chart below,
ERROR
will
appear in the display.
2. CompuDefrost can be programmed with More or
Less Time Adjustment. Touch the
POWER LEVEL
pad once or twice after selecting the weight. See
page 16.
3. To defrost other foods or foods above or below
the weights allowed on CompuDefrost Chart. Use
time and 30% power. See Manual Defrost on
page 16.
4. You may choose to enter the weight in tenths of
pounds. This procedure may be easier with larger
weights such as 4 pounds because it requires
fewer touches. To program, touch desired
COMPU
DEFROST
pad and enter weight by touching the
number pads. Ex: touch
STEAKS/CHOPS
then 4
and 0 for a weight of four pounds or touch
STEAKS/
CHOPS
then 2 and 2 for a weight of 2.2 lb.
5.
To use any CompuDefrost pad, touch within 1 minute
after cooking, opening and closing the door or
touching the
STOP/CLEAR
pad.
PROCEDURE
DISPLAY
1
Quickly touch
STEAK/CHOPS
pad 4 times for
2.0 lb. The oven will start automatically.
2
After the 1st stage, open the door, turn steak
over and shield any warm portions. Close the
door.
STEAKS/
CHOPS
2.0
LBS
DEF HELP
The oven will stop and directions will be
displayed.
Follow the indicated message.
START
Touch
START
pad.
3
After the 2nd stage, open the door and shield
any warm portions. Close the door.
START
Touch
START
pad.
4
After defrost cycle ends, cover and let stand
as indicated in chart below.
NOTE:
Check foods when oven signals. After final stage, small sections may still be icy. Let stand to continue
thawing. Do not defrost until all ice crystals are thawed.
Shielding prevents cooking from occurring before the center of the food is defrosted. Use small smooth
strips of aluminum foil to cover edges and thinner sections of the food.
FOOD
AMOUNT
COMPU DEFROST CHART
PROCEDURE
Remove any thawed pieces after each stage.
Let stand, covered, for 5 to 10 minutes.
Ground Meat
.5 - 3.0 lb
After each stage, rearrange and if there are warm or thawed por-
tions, shield with small flat pieces of aluminum foil. Remove any
meat or fish that is nearly defrosted.Let stand, covered, for 10 to
20 minutes.
Steaks/Chops (Fish)
.5 - 4.0 lb
After each stage, if there are warm or thawed portions, rearrange
or remove. Let stand, covered, for 10 to 20 minutes.
Chicken Pieces
.5 - 3.0 lb
x 4