Sharp VLAH150U Operation Manual - Page 26
Using the Hand Strap and the, Lens Cap, Attaching the Shoulder Strap
UPC - 074000352735
View all Sharp VLAH150U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Preparation Preparation Using the Hand Strap and the Lens Cap 1 Open the hand strap flap (Q) and grip strap (W), and pass the grip strap through the loop at the end of the lens cap cord (E). Hand strap flap Grip strap 2 Pass your hand through the hand strap and put your thumb close to the Power Zoom control. Then pull the grip strap tight until it fits snugly, seal the Velcro® closures (Q), and close the hand strap flap (W). Notes: • Always replace the lens cap on the lens when the VIEWCAM is not in use. • Attach the lens cap to the hand strap so it will not get in the way during recording. Attaching the Shoulder Strap 1 Hold one end of the strap and thread it through the loop on the left side of the LCD screen. 2 Loosen the strap in the buckle, then feed the end of the strap through the buckle, as shown. 3 Draw the strap in the direction of the arrow to secure. 4-6 Use the same procedure to attach the other end of the strap to the loop on the lens side. Caution: • Do not swing the VIEWCAM by the hand strap. Attaching and Removing the Lens Cap When attaching or removing the lens cap, press both tabs on the sides of the cap. Press both tabs. LCD screen side 1 2 Buckle Lens side 4 5 Buckle 3 6 17