Sharp XE-A506 Quick Start Guide - Page 1
Sharp XE-A506 Manual
UPC - 074000049550
View all Sharp XE-A506 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
XE-A506 Quick Start Guide The following describes how to get the cash register ready for operation. Follow these steps before using the cash register for the first time. Place the cash register on a stable, flat surface not subject to direct sunlight. English 1 Connecting the Barcode Scanner 2 Initializing the Cash Register A barcode scanner is provided with the cash register. To use the scanner, connect the scanner before turning on the register. 1. Open the Scanner port cover at the right side of the register. 2. Insert the connector of the barcode scanner into the Scanner port, and tighten both screws on the connector. CAUTION: • Always unplug the power cord of the cash register when you connect or disconnect the barcode scanner. • Never connect devices other than the barcode scanner before changing the interface setting. Otherwise malfunction of the cash register will occur. To ensure the cash register operates properly, please use the following procedure: 1. Make sure the power cord plug is not inserted into the AC outlet. 2. Insert the manager (MA) key into the mode switch and turn it to the PGM position. 3. While holding down both the } key and the l key, insert the plug into the AC outlet. The buzzer will sound three times and "***MRS.***" will be displayed. MA REG OPX/Z MGR OFF X1/Z1 VOID X2/Z2 PGM 4. The cash register has now been initialized. The register display will show "0.00" with "PGM". CAUTION: To charge the rechargeable batteries, keep the power on for one or two days. Leave the register with the mode switch in a position other than "OFF". NOTE: If you press a key by mistake, an error message may be displayed. Press the l key to clear message after installing paper rolls. 3 Preparing the Cash Register 4 Installing the Paper Rolls 1. Push the printer cover forward and detach it. 2. Remove the white retainer at the position shown right. NOTE: Please keep this retainer for future use when transferring the cash register. 3. Move the print head release lever upwards as illustrated right. Retainer Print head release lever 1. Cut off approximately one revolution of each paper roll. Make sure the paper end is cut as illustrated right. Correct Incorrect For receipt paper installation 2. Set a paper roll in the paper cradle of the receipt side (upper side) as illustrated right. To the printer Correct To the printer Incorrect 3. Insert the end of the paper into the paper chute until it is caught by the printer auto-feed and comes out the top of the printer. If the printer does not catch the paper, feed the paper while pressing }. 4. Cut off the excess paper with the paper cutter. For journal paper installation 5. Set a paper roll in the paper cradle of the journal side as illustrated in step 2. 6. Insert the end of the paper into the paper chute until it is caught by the printer auto-feed and comes out the top of the printer. If the printer does not catch the paper, feed the paper while pressing } as illustrated in step 3. 7. Insert the end of the paper into the slit in the take-up spool and fold the paper to front side, then wind the paper two or three turns around the spool shaft. (Press } Slit to feed more paper if required.) 8. Set the spool on the bearing, and press the } key to take up excess slack in the paper. 9. Replace the printer cover.