Sharp XL-55 Instruction Manual - Page 18

CD Playback

Get Sharp XL-55 PDF manuals and user guides View all Sharp XL-55 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

XL-55H ENGLISH Listening to a CD (continued) To interrupt playback: Main unit operation: Press the button. To resume playback from the same point, press the Remote control operation: Press the button. To resume playback from the same point, press the button again. button. To stop playback: Press the button. To remove the CD: Whilst in the stop mode, press the CD EJECT button. After use: Press the ON/STAND-BY button to enter the power stand-by mode. CD Playback Caution: ! If a disc is damaged, dirty, or loaded upside down, "NO DISC" or "READ ERR" will appear on the display. ! Keep foreign objects out of the CD compartment. ! Subjecting the unit to shock or vibration may cause mistracking. ! When the unit is not being used, be sure to close the CD com- partment. If it is left open, the lens may be covered with dust and the unit may not operate properly. ! If TV or radio interference occurs during CD operation, move the unit away from the TV or radio. " Care of compact discs Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player. ! Do not write on either side of the disc, particularly the non-label side from which signals are read. Do not mark this surface. ! Keep your discs away from direct sunlight, heat, and excessive moisture. ! Always hold the CDs by the edges. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius. NO YES Correct " To locate the beginning of a track To move to the beginning of the next track: Press the button for less than 0.5 seconds during playback. ! You can skip to any track by pressing the button repeatedly until the desired track number appears. To restart the track being played: Press the button for less than 0.5 seconds during playback. ! You can skip to any track by pressing the button repeatedly until the desired track number appears. E-11 02/12/20 XL_55H_H_E2.fm Downloaded From Disc-Player.com Sharp Manuals

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
02/12/20
XL_55H_H_E2.fm
E-11
ENGLISH
XL-55H
CD Playback
Listening to a CD (continued)
To interrupt playback:
Main unit operation:
Press the
button.
To resume playback from the same point, press the
button again.
Remote control operation:
Press the
button.
To resume playback from the same point, press the
button.
To stop playback:
Press the
button.
To remove the CD:
Whilst in the stop mode, press the
CD EJECT button.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Caution:
!
If a disc is damaged, dirty, or loaded upside down, "NO DISC" or
"READ ERR" will appear on the display.
!
Keep foreign objects out of the CD compartment.
!
Subjecting the unit to shock or vibration may cause mistracking.
!
When the unit is not being used, be sure to close the CD com-
partment. If it is left open, the lens may be covered with dust and
the unit may not operate properly.
!
If TV or radio interference occurs during CD operation, move the
unit away from the TV or radio.
"
Care of compact discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
!
Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
!
Keep your discs away from direct sunlight, heat, and excessive
moisture.
!
Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
"
To locate the beginning of a track
To move to the beginning of the next track:
Press the
button for less than 0.5 seconds during playback.
!
You can skip to any track by pressing the
button repeatedly until the desired track
number appears.
To restart the track being played:
Press the
button for less than 0.5 seconds during playback.
!
You can skip to any track by pressing the
button repeatedly until the desired track
number appears.
NO
YES
Correct
Downloaded From Disc-Player.com Sharp Manuals