Sharp XR-30S Operation Manual - Page 28
Controlling the Projector by a Computer, Connecting the Power Cord
UPC - 074000365216
View all Sharp XR-30S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Controlling the Projector by a Computer When the RS-232C terminal on the projector is connected to a computer with a DIN-D-sub RS232C adaptor (optional, AN-A1RS) and an RS-232C serial control cable (cross type, commercially available), the computer can be used to control the projector and check the status of the projector. See page 55 for details. When connecting to a computer using an RS-232C serial control cable and a DIND-sub RS-232C adaptor To RS-232C terminal DIN-D-sub RS-232C adaptor (optional, AN-A1RS) To RS-232C terminal Computer RS-232C serial control cable (cross type, commercially available) Note • The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the operation manual of the computer for details. • See pages 53 and 54 for connection of an RS-232C serial control cable. Info • Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may damage your computer or projector. • Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This may damage your computer. Connecting the Power Cord Plug the supplied power cord into the AC socket on the rear of the projector. Then plug into AC outlet. Supplied accessory AC socket To AC outlet 24 Power cord (supplied)