Sharp XV-Z10000U XV-Z10000 Operation Manual - Page 87
For SHARP Assistance U.S.A only
UPC - 074000358836
View all Sharp XV-Z10000U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Troubleshooting Problem Picture is green on INPUT 1 or 2 COMPONENT. Picture is pink (no green) on INPUT 1 or 2 RGB. Picture is dark. Picture is too bright and whitish. A response code cannot be received when the projector was attempted to be controlled using RS-232C commands from a computer during standby. Check • Change the input signal type setting. • The lamp replacement indicator is blinking in red. Replace the lamp. • Picture adjustments are incorrectly set. • In the case of transmitting RS-232C commands from a computer during standby, it takes a maximum of 30 seconds for the computer to receive the response code. Set the response code waiting time of the computer to 30 seconds or more. Page 64 74 44 80 For SHARP Assistance (U.S.A only) If you encounter any problems during setup or operation of this projector, first refer to the "Troubleshooting" section on this page. If this operation manual does not answer your question, please call toll free 1-877-DTV-SHARP (1-877-388-7427) for further assistance. Or, send us an e-mail at [email protected] . Our World Wide Web address is http://www.sharpusa.com/ . -86