Sharp XV-Z3100 Operation Manual - Page 30
Basic Operation, Turning the Projector On/Off, Connecting the Power Cord
UPC - 074000365162
View all Sharp XV-Z3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Turning the Projector On/Off Connecting the Power Cord Plug the supplied power cord into the AC socket on the rear of the projector. Then plug into AC outlet. Supplied accessory Power cord AC socket To AC outlet Turning the Projector on Note that the connections to external equipment and power outlet should be done before performing the operations written below. (See pages 23 to 28.) Remove the lens cap and press S STANDBY/ON on the projector or bON on the remote control. Info • English is the factory default language. If you want to change the on-screen display to another language, change the language according to the procedure on page 50. Lamp indicator Power indicator Note • About the Lamp Indicator The lamp indicator illuminates to indicate the status of the lamp. Green: The lamp is on. Blinking in green: The lamp is warming up or shutting down. Red:The lamp is shut down abnormally or the lamp should be replaced. • When switching on the projector, a slight flickering of the image may be experienced within the first minute after the lamp has been illuminated. This is normal operation as the lamp's control circuitry is stabilising the lamp output characteristics. It should not be regarded as faulty operation. • If the projector is put into standby mode and immediately turned on again, the lamp may take some time to start projection. STANDBY/ON button ON button 28