Singer 1 One Instruction Manual 4 - Page 11
chainstitching.
View all Singer 1 One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
The Even Feed Foot • Guide EvenFeed foot into position from back of machine, making sure the movable arm straddles the needle clamp. Tighten presser-foot screw securely with a coin. To remove, loosen screw and guide foot to the right and away from you. Movable Arm Fit Needle Clamp CHANGING PLATES (Note: Remove bobbin if it contains thread in order to prevent thread being caught when plate is replaced.) 1. Raise take-up lever to its highest position by turning the hand wheel toward you. 2. Raise presser foot. 3. Open slide plate. Press down on front edge of plate and lift up and out. 4. Position new plate over pins and release. Plate is drawn into position by magnets. See special instructions on page 30 for attaching straight-stitch plate for chainstitching. 5. Close slide plate. Changing Even Feed Foot 1i I II 54 3 iii 1 3456 Removing Needle Plate 5