Singer SM024 User Manual - Page 10

KNOWING YOUR SEWING MACHINE Removing or replace the bobbin case 1. Refer to page 4 to take off the removable storage compartment. Raise the needle by turning the hand wheel toward you, then open the shuttle cover. 2. Take out bobbin case holding the latch. 3. When installing the bobbin case, the pin on the case should fit into the gap of the shuttle race. CAUTION Be sure to disconnect the power supply before operating the machine. Gap Threading the bobbin case 1. Install the bobbin into bobbin case. Make sure the thread unwinds in the direction of arrow (clockwise). 2. Pull the thread into the groove in the bobbin case slot. 3. Now pull the thread under the tension spring and into the delivery eye. NOTE: Leave about 10cm (4 inches) of the thread hanging out of the bobbin case. When you pull the thread, the bobbin should spin clockwise. Changing the presser foot 1. Turn the hand wheel toward you to raise the needle to its highest position. Raise the presser foot. 2. Press the lever on the back of the presser foot holder. The presser foot will drop off. 3. Place the presser foot so the pin on the foot lies just under the groove of the holder. Lower the presser foot holder to lock the foot in place. 6