Smeg FAB28UOR Owners Manual - Page 19
are cracked, try to soften
View all Smeg FAB28UOR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Instructions for the User PROBLEM Too much ice forming on back wall of refrigerator section (layer of frost more than 3/8" - 1 cm thick): - Too much ice forming in freezer - Front of cabinet hot to the touch POSSIBLE CAUSE Cooling temperature regulator device set too high (meaning lower temperature inside the appliance); - door opened often or for long periods; - - inside temperature setting thermostat set on too low a temperature; - - - - - PROBABLE SOLUTION Turn the regulator to a lower setting (1-2) to increase the temperature inside the appliance slightly; check that the gaskets are providing an airtight seal; open the door less often and for shorter times; rise in atmospheric temperature and humidity; do not place hot food or drinks inside the refrigerator; Turn the regulator to a lower setting (1-2) to increase the temperature inside the appliance slightly; check that the gaskets are providing an airtight seal: If they are cracked, try to soften the gasket by pulling it with one hand and sliding your closed fingers along the inside; open the door less often and for shorter times; rise in atmospheric temperature and humidity; do not place hot food or drinks inside the freezer; the refrigerator is operating normally. Inside the cabinet there is a surface cooling system designed to restrict the formation of condensation in the area where the door gasket closes. 21