Smeg FAB5URP Instruction Manual - Page 9

Instructions for the User 3.4 Electrical requirements WARNING Electrical Shock Hazard. Plug into a grounded 3-prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. NOTE: Before you move your absorption minibar into its final location, it is important to make sure you have the proper electrical connection. • Before switching the absorption minibar on for the first time, leave it vertical for at least two hours. Then connect the appliance's power supply lead to a main socket with earth contact, installed in accordance with electrical safety regulations. The rated voltage and frequency are stated on the nameplate inside the minibar compartment. • The appliance must be connected to the electrical mains and earthed in compliance with the relevant regulations and requirements. The appliance is able to withstand short fluctuations in voltage of no more than 15% less or 10% more than the rated voltage stated on the nameplate. • If the power supply lead has to be replaced, this operation must only be carried out by an authorised technical service engineer. • The socket must be accessible after the appliance has been placed. 3.4.1 Recommended Grounding Method A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your absorption minibar be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation or cleaning, turn the control (Thermostat, absorption minibar) on position 0 (STOP) and then disconnect the absorption minibar from the electrical source. When you are finished, reconnect the absorption minibar to the electrical source and reset the control (Thermostat, absorption minibar) to the desired setting. 9