Smeg KT90XU Instruction Manual - Page 4
Installation Instructions
View all Smeg KT90XU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION INSTRUCTIONS: The hood is supplied with all the necessary accessories for installation. The minimum distance between the cooker and the lower part of the hood must be 750 mm for gas cookers and 650 mm for electric cookers (Fig.1). The hood is supplied with a motor intake (Fig 2). If it has not been assembled by the manufacturer, you can assemble it using the supplied screws (for type 1) or pushing (for type 2) If the motor intake is equipped with a non-return valve, make sure it opens and closes perfectly. The following instructions will assist installation: a) The hood should be centred with respect to the cooker. b) The hood is supplied with two supports/hooks (a) (Fig 3) or bracket (b) that need to be fixed to the wall by means of wall anchors . The L1 holes for these supports are on the back of the hood (fig.4) c) Remove the anti-grease filters, put the hood on the wall and mark the position of the holes for the supports/hooks. d) Drill the two previously marked holes after removing the hood from the wall. e) Fix the two supports/hooks to the wall. f) Mark the L2 holes on the wall to fix the hood safely. (fig. 4) Drill and put the anchors in the holes. g) Hang the hood on to the supports/hooks (fig. 5) and level by means of the adjusting screw (fig.3). l) Fix the hood safe by tightening both wall anchors. Ducted mode or Recirculation mode installation: Ducted mode: In the ducted mode, connect the motor outlet to the fumes outlet duct not less than 120mm diameter. Warning: if the hood is equipped with an active carbon filter, it must be removed (see page7) EN 4