Smeg SEU244ETB Instruction Manual 2 - Page 4

Installation

Page 4 highlights

Installation 1 Installation 1.1 General installation instructions • Proper installation is your responsibility. Have a qualified technician install this appliance. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with installation guidelines specified on the model/serial ID plate. The model/serial ID can be found under the appliance. • Have your appliance installed and properly grounded by a qualified installer, in accordance with these installation instructions. Grounding is mandatory according to the provisions of the electrical system safety regulations. If this appliance is connected to an outside electrical power source, it must be grounded in compliance with local laws, or, if no local laws exist, in compliance with the national ANSI/NFPA 70 code of electrical regulations. • Make sure that the voltage and dimensions of the supply line correspond to the information indicated on the model/serial rating plate. A multi-pole circuit breaker must be available on the supply line with contact gap equal to or greater than 3mm, located in an easily accessible position near the appliance. • Do not attempt to repair or replace any part of the appliance unless specifically recommended in this manual. All other service procedures should be performed by a qualified technician. • This appliance is not suitable for installation and use in mobile homes or campers. • Electrical grounding is required. See the "Electrical requirements" section. It is the customer's responsibility to: 1. Contact a qualified electrical installer. 2. Ensure that the electrical system is adequate and in compliance with the national ANSI/NFPA 70 ELECTRICAL CODE - latest edition - or the CANADIAN ELECTRICAL CODE, C22.11 - 1982 and C22.2 No. 01982 - or latest edition - and all local codes and ordinances. IMPORTANT: Observe all codes and ordinances in force. In case of multiple installations, cooktops can not be installed adjacent to each other. 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10

Installation
6
1 Installation
1.1 General installation instructions
Proper installation is your
responsibility.
Have a qualified
technician install this appliance. Make
sure you have everything necessary for
correct installation. It is the responsibility
of the installer to comply with installation
guidelines specified on the model/serial
ID plate. The model/serial ID can be
found under the appliance.
Have your appliance installed and
properly grounded by a qualified
installer, in accordance with these
installation instructions.
Grounding is
mandatory according to the provisions of
the electrical system safety regulations. If
this appliance is connected to an outside
electrical power source, it must be
grounded in compliance with local laws,
or, if no local laws exist, in compliance
with the national ANSI/NFPA 70 code
of electrical regulations.
Make sure that the voltage and
dimensions of the supply line correspond
to the information indicated on the
model/serial rating plate. A multi-pole
circuit breaker must be available on the
supply line with contact gap equal to or
greater than 3mm, located in an easily
accessible position near the appliance.
Do not attempt to repair or replace any
part of the appliance unless specifically
recommended in this manual. All other
service procedures should be performed
by a qualified technician.
This appliance is not suitable for
installation and use in mobile homes or
campers.
Electrical grounding is required.
See
the “Electrical requirements” section. It is
the customer’s responsibility to:
1. Contact a qualified electrical installer.
2. Ensure that the electrical system is
adequate and in compliance with the
national ANSI/NFPA 70 ELECTRICAL
CODE - latest edition - or the
CANADIAN ELECTRICAL CODE,
C22.11 - 1982 and C22.2 No. 01982
- or latest edition - and all local codes
and ordinances.
IMPORTANT: Observe all codes and
ordinances in force.
In case of multiple installations,
cooktops can not be installed
adjacent to each other.