Smeg STFABURD-1 Instruction Manual 1 - Page 17

Operating Instructions

Get Smeg STFABURD-1 PDF manuals and user guides View all Smeg STFABURD-1 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

EENN UUUUSSESSEREERRRINIIINNNSSTSSTTTRRRRUUUUCCCCTTTTIOIIIOOONNNNSS EN 5 5 OOPPEERRAATTIINNGG IINNSSTTRRUUCCTTIIOONNSS BRTBRTEEEEEERRFFAAOODD22RR""AAEEIIMMNNSSDDPPTTOOAAUURRRRNNTTTTDDAAIINNEENNGGRRTTSSTTSSTTOOAAOOFFOOUUEEDDTTSSEEYYAAIITTLLNNHHLLSSEETTTTHHRRAAEEUUPPWWCCPPTTLLAAIIIIAAOORRNNNNNNCCII""NN..EEGG,, MMSS CCAAOOKKEENNTTSSAAUUIIRRNNEEEEDDYYOOIINNUUCCHHHHAAAAVVPPEE-- OOnnccee tthhee ddiisshhwwaasshheerr hhaass bbeeeenn ccoorrrreeccttllyy iinnssttaalllleedd,, pprreeppaarree ffoorr uussee aass ffoolllloowwss:: • aaddjujussttththeewwaateterrssooftfetennininggssyysstetemm; ; • aaddddththeerereggeenneeraratitninggssaaltl;t; • aaddddththeerirninssee-a-aididaannddddeetetergrgeennt.t. 5.12 Using the wrinaster-asiodftaenndindgesteyrsgteemnt dispensers TThhee daemteorugnetnotfasncdalerincosentaaiidneddisipnetnhseerwsaatreer s(wituaateter dhaorndnthesesiinnndeerxp) caartnocfatuhsee dwohoitr-: itshhestdaientienrggoentthdeidspryednissehres(,rwefh. icAh tfiegn.d5t-o03b)ecios moendtuhlleovleefrt,timaned. Ththeedisrihnwsaes-ahiedr idsisepqeunipspeer d(rewf.itBhfiagn. 5a-u0t3o)misaotnicthsoefrtiegnhint.g system which uses a special regenerating salt to reduce the hardness of the water. The dishwasher is factory set for water hardness level 3 (average hardness 41-60°dF - 24-31°dH / 23.6-35 gpg). When using water ofAmedium hardness, the regenerating salt container should be refilled after approximately 20 washing cycles. The salt container can hold approximately 1.7 Kg (3.75 lb) of salt in grains. Some models are equipped with an optical no-salt indicator. In these models, the cap of the salt container contains a green float which descends as the salt concentration in the water drops. When the greenBfloat can no longer be seen, the container must be topped up with regenerating salt. The container is situated at the bottom of the dishwasher. After removing the lower rack, unscrew the salt container cap (ref. A fig. 5-01) by turning it anticlockwise and pour in the salt using the funnel (ref. A fig. 5-02) supplied with the dishwasher. Before replacing the cap (ref. A fig. 5-01), remove any salt residues from around the opening. Fig. 5-03 WITH THE EXCEPTION OF THE SOAK PROGRAM, BEFORE EVERY WASHING CYCLE IT IS NECESSARY TO ADD THE REQUIRED AMOUNT OF DETERGENT TO THE DETERGENT DISPENSER. THE RINSE AID, ON THE OTHER HAND, SHOULD ONLY BE ADDED AS REQUIRED. A Fig. 5-01 12680 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
USER INSTRUCTIONS
17
EN
5
OPERATING INSTRUCTIONS
BEFORE STARTING TO USE THE APPLIANCE, MAKE SURE YOU HAVE
READ AND UNDERSTOOD ALL THE WARNINGS CONTAINED IN CHAP-
TER 2 “IMPORTANT SAFETY INSTRUCTION”.
Once the dishwasher has been correctly installed, prepare for use as follows:
•
add the rinse-aid and detergent.
•
adjust the water softening system;
•
add the regenerating salt;
5.1
Using the water softening system
The amount of scale contained in the water (water hardness index) can cause whit-
ish staining on the dry dishes, which tend to become dull over time. The dishwasher
is equipped with an automatic softening system which uses a special regenerat-
ing salt to reduce the hardness of the water. The dishwasher is factory set for water
hardness level 3 (average hardness
41-60°dF – 24-31°dH / 23.6-35 gpg
). When us-
ing water of medium hardness, the regenerating salt container should be refilled
after approximately 20 washing cycles. The salt container can hold approximately
1.7 Kg (3.75 lb)
of salt in grains. Some models are equipped with an optical no-salt
indicator. In these models, the cap of the salt container contains a green float which
descends as the salt concentration in the water drops. When the green float can no
longer be seen, the container must be topped up with regenerating salt. The con-
tainer is situated at the bottom of the dishwasher. After removing the lower rack,
unscrew the salt container cap (ref. A fig. 5-01) by turning it anticlockwise and pour
in the salt using the funnel (ref. A fig. 5-02) supplied with the dishwasher. Before re-
placing the cap (ref. A fig. 5-01), remove any salt residues from around the opening.
A
Fig. 5-01