Snapper NXT2242 Parts Manual - Page 62

8 7 6 5 4 3 2 1 H RED/WHT ALTERNATOR ENGINE CONNECTOR 41 PURPLE 52 63 MAGNETO STARTER SOLENOID FUEL G SHUTOFF YELLOW/RED PURPLE ENABLE KEY N.C. PUSH BUTTON SWITCH BLU/WHT BLACK BOX 71 82 93 TAN 10 4 11 5 12 6 BLACK BOX 1-12V CHASSIS GRND THE FOLLOWING SAFETY STARTING & RUNNING CONDITIONS MUST BE MET FOR ALL ELECTRICAL WIRING, SWITCHES AND RELATED COMPONENTS. 2-ENABLE KEY IN 1) ALL UNITS MUST BE TESTED FOR CORRECT WIRING & FUNCTION OF ALL 3-PUSH BUTTON IN CIRCUITS AND SWITCHES. H 4-12V + IN 2) ENGINE OPERATION MUST STOP WHEN THE FOLLOWING CONDITIONS PREVAIL: 5-STARTER SOLENOID 12V A) IGNITION SWITCH IS PLACED IN THE OFF POSITION. 6-OPEN (3.3V/LED FUTURE) B) THE OPERATOR IN NOT SEATED WITH EITHER THE CLUTCH/BRAKE PEDAL 7-OPEN (PROGRAM.UART Rx) RELEASED (UP) OR THE PTO IN THE ENGAGED POSITION. 8-PTO/BRAKE 12V START C) TRANSMISSION IS PUT IN REVERSE WITHOUT OVERRIDE MODULE ENGERIZED. 9-OPEN (PROGRAM.UART TX) 3) ENGINE MUST NOT START BY CONVENTIONAL MEANS UNLESS ALL OF THE 10-SEAT SENDSOR FOLLOWING CONDITIONS ARE MET. EACH CONDITION MUST BE CHECKED 11-MAGNETO KILL TO INSURE PROPER OPERATING SEQUENCES: 12-12V LOAD RELAY A) IGNITION SWITCH IS INTENTIONALLY PLACED IN THE START POSITION. B) THE PTO SWITCH IS IN THE DISENGAGED POSITION. C) CLUTCH/BRAKE PEDAL MUST BE FULLY DEPRESSED. 4) ENGINE MUST REMAIN RUNNING IF OPERATOR IS SEATED AND THE FOLLOWING CONDITIONS ARE MET (CHECK THOROUGHLY TO INSURE PROPER OPERATION): A) TRANSMISSION IS ENGAGED (CLUTCH/BRAKE PEDAL IS RELEASED (UP)). B) PTO IS ENGAGED AND OVERRIDE MODULE ENGERIZED. 5) FUNCTION OF SEAT SWITCH MUST BE TESTED WITH SWITCH MOUNTED IN PROPER POSITION IN SEAT. G WHITE RED/YEL BLUE BROWN BLUE YELLOW/RED BLACK RED F PURPLE BLUE E PTO ELECTRIC CLUTCH SPLICE "C" YELLOW/RED YELLOW/RED ORANGE BLACK SPLICE "D" YELLOW/RED YELLOW/RED ORANGE YELLOW 20 AMP FUSE RED RED RED A SHORTING CONNECTOR IS USED ON THE SEAT F SWITCH CONNECTOR 87A 87 85 RELAY 86 SWITCH 30 TAN SEAT SWITCH (SEAT UNOCCUPIED) N.C. TAN BLACK SPLICE "B" PTO INTERLOCK SWITCH (PTO DISENGAGED) GREEN TAN START N.C. RUN N.O. BLUE PURPLE YELLOW/RED PTO ORANGE N.O. E PURPLE BLACK D NO-MOW MODULE C N.O. REVERSE PEDAL SWITCH B PURPLE BLACK AUXILARY 12V CONNECTOR ORANGE BLACK HEADLIGHT SWITCH (N.O.) GRAY BLACK HEADLIGHTS BLACK BLACK SPLICE "A" ENGINE BOLT YELLOW/BLACK YELLOW/RED YELLOW/RED YELLOW/RED YELLOW/RED YELLOW/RED YELLOW/RED BLACK RED YELLOW/RED BLACK BLACK PURPLE BLACK ENGINE BOLT BLACK - + BATTERY BLACK SPLICE "E" RED - SOLENOID B + S BLACK STARTER BLACK BLACK YELLOW/RED Y/R BLK 9 10 51 62 73 84 11 12 ELECTRIC HEIGHT OF CUT BLK Y/R PURPLE/WHITE BLACK 1 CONNECTION FOR EHOC 2 FUEL SENDER BLACK BLACK BLACK BLACK BLACK DASH 1-BATTERY+ 2-BATTERY3-IGN. POWER 4-MOWER SENSOR 5-FUEL SENSOR 6-CHASSIS GRND 7-BLANK 8-BLANK 9-SPEED INPUT 10-BLANK 11-RMO 12-BLANK BLACK RED RED 12 1 11 2 10 3 94 85 76 DASH PLUG YELLOW/RED GRN/WHT RED/PUR BLACK GREEN PURPLE TAN YELLOW PEDAL SWITCHES (PEDAL UP) RUN N.C. START N.O. D GREEN HEIGHT OF CUT GAGE HEIGHT OF C CUT SENSOR 1 GRN/WHT 2 SPLICE 3 "F" YELLOW/RED GREEN/WHITE FOR WIRING HARNESS RED B BLACK 1 2 3 MAINTENANCE MINDER YELLOW/RED YELLOW/RED REFER TO 3-D DATA FOR ADDITIONAL INFORMATION THIS DRAWING IS PROPRIETARY PROPERTY OF BRIGGS & DIMENSIONING AND SIZE BRIGGS & STRATTON CORP. STRATTON CORPORATION DISCLOSED IN CONFIDENCE, WHICH MAY NOT BE USED OR TOLERANCING PER ASME Y14.5M-1994 E DISCLOSED WITHOUT A REV. CHANGES: BY DOC. NO. DATE PERMISSION. RETURN PROMPTLY AFTER USE. SCALE: UNCONTROLLED DOCUMENT WHEN PRINTED A - INITIAL DRAWING RELEASE TJR ECR007626 09/21/09 UNLESS OTHERWISE SPECIFIED, ALL DIMENSIONS ARE IN INCHES. TOLERANCE UNLESS OTHERWISE SPECIFIED: TITLE: WIRING SCHEMATIC A ADDED WIRING FOR OPTIONAL CHUTE ROTATION (A6) TJR ECR008221 11/02/09 .X # 0.1 B REMOVED WIRING FOR OPTIONAL CHUTE ROTATION (A6) C ADDED MAINTENANCE MINDER WIRING (B2); REMOVED SPOUT ROTATOR SWITCH FROM HEIGHT TJR ECR008931 TJR ECR009107 01/06/10 02/02/09 CLASSIFICATION OF CHARACTERISTICS .XX # 0.03 .XXX # 0.015 ANGLES # 2.0 MATERIAL: OF CUT DESCRIPTION (B5) DOUBLE MAJOR(MM_00) CRITICAL(C__00) MAJOR(M__00) THIRD ANGLE PROJECTION DRAWN: DCH 09/21/09 SIMILAR TO: - APPR: - - DO NOT SCALE DRAWING 1738721 REV SHEET 1 C OF 1 8 7 6 5 4 3 2 1