Sony AVD-K700P Operating Instructions - Page 12

Connections (Continued) Basic TV Connections Make one of the following connections, depending on the capabilities of your TV. RF coaxial connection Connect the ANTENNA OUT jack on the DVD/VCR Receiver to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R). Note If you use this connection, tune the TV to the DVD/VCR Receiver's RF output channel (CH 3 or 4). How to set the DVD/VCR Receiver's RF output channel When the DVD/VCR Receiver is turned off, press and hold CH/PRESET(+/-) on the front panel for about five seconds to change the RF output channel (CH 03 or CH 04). "RF-03" or "RF-04" appears in the display window. Audio/Video connection 1 Connect the VIDEO OUT jack on the DVD/VCR Receiver to the video in jack on the TV using the supplied video cable (V). 2 Connect the Left and Right AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables. Note If you use this connection, set the TV's source selector to VIDEO. Rear of TV AUDIO INPUT L R VIDEO INPUT COMPONENT/PROGRESSIVE SCAN VIDEO INPUT L Pr Pb Y ANTENNA INPUT A V C R Optional TV Connections Note DVD playback can ONLY be done using the COMPONENT VIDEO OUT connection options below. The tuner and VIDEO will still output through the ANTENNA OUT (R) or AUDIO/VIDEO OUT (A, V) jack. (See left) Component Video (Color Stream®) connection 1 Connect the COMPONENT VIDEO OUT jacks on the DVD/VCR Receiver to the corresponding in jacks on the TV using a component video cables (C). 2 Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables. Progressive Scan (ColorStream® pro) connection If your television is a high-definition or "digital ready" television, you may take advantage of the DVD/VCR Receiver's progressive scan output for the highest video resolution possible. If your TV does not accept the Progressive Scan format, the picture will appear scrambled if you try Progressive Scan on the DVD/VCR Receiver. 1 Connect the COMPONENT VIDEO OUT jacks on the DVD/VCR Receiver to the corresponding in jacks on the TV using a component video cables (C). 2 Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables. Notes Set the Progressive Scan to "On" on the DVD setup menu for progressive signal, see page 21. Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack). Rear of DVD/VCR Receiver 12