Sony BDP-S780 Operating Instructions - Page 28

Audio Settings Audio (HDMI) Auto: Normally select this. Outputs audio signals according to the status of the connected HDMI device. PCM: Outputs PCM signals from the HDMI OUT jack. DSD Output Mode On: Outputs DSD signals from the HDMI OUT jack when playing a Super Audio CD. When "On" is selected, no signal is output from other jacks. Off: Outputs PCM signals from the HDMI OUT jack when playing a Super Audio CD. BD Audio MIX Setting On: Outputs the audio obtained by mixing the interactive and secondary audio to the primary audio. Off: Outputs the primary audio only. Select this to output HD audio signals to an AV amplifier (receiver). Dolby Digital Downmix PCM: Converts to output Linear PCM signals. Select this when connecting an audio device without a built-in Dolby Digital decoder. Dolby Digital: Select this when connecting an audio device with a built-in Dolby Digital decoder. DTS Neo:6 Cinema: Outputs the simulated multi-channel sound from 2 channel sources via the HDMI OUT jack according to the capability of the connected device using "DTS Neo:6 Cinema" mode. Music: Outputs the simulated multi-channel sound from 2 channel sources via the HDMI OUT jack according to the capability of the connected device using "DTS Neo:6 Music" mode. Off: Outputs the sound with its original number of channels via the HDMI OUT jack. Audio DRC Auto: Performs playback at the dynamic range specified by the disc (BD-ROM only). Other discs are played back at the "On" level. On: Performs playback at a standard compression level. Off: No compression works. A more dynamic sound is produced. Downmix Surround: Outputs audio signals with surround effects. Select this when connecting an audio device that supports Dolby Surround (Pro Logic) or DTS Neo:6. Stereo: Outputs audio signals without surround effects. Select this when connecting an audio device that does not support Dolby Surround (Pro Logic) or DTS Neo:6. DTS Downmix PCM: Converts to output Linear PCM signals. Select this when connecting to an audio device without a built-in DTS decoder. DTS: Select this when connecting to an audio device with a built-in DTS decoder. 28