Sony CDX-454RF Operating Instructions - Page 5
Changing the transmitting, frequency - remote
View all Sony CDX-454RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Note You cannot play 8cm (3in.) CDs. If the disc magazine does not lock properly Take out the disc magazine, press Z, and reinsert it. Use the unit with the door closed completely Otherwise, foreign matter may enter the unit and contaminate the lenses inside the CD changer. Notes on the disc magazine •Do not leave the disc magazine in locations with high temperature and high humidity, such as on a car dashboard or in the rear window where the disc magazine will be subject to direct sunlight. •Do not place more than one disc at a time onto a tray, otherwise the CD changer and the discs may be damaged. •Do not drop the disc magazine or subject it to a violent shock. When the tray comes out Normally, the trays will not come out of the disc magazine. However, if they are pulled out of the disc magazine, it is easy to re-insert them. Changing the transmitting frequency Because this unit processes CD playback sound through an FM tuner, there may be interference noise during CD playback. In such a case, change the frequency of the modulated RF signal transmitted from the unit. The initial setting is 88.3 MHz. 1 Press (SHUF/REP) for two seconds until frequency appears. 2 Press or repeatedly to select the frequency. Each time you press or , the frequency changes as follows: : 88.3 MHz t 89.9 MHz t 89.7 MHz t 89.5 MHz t 89.3 MHz t 89.1 MHz t 88.9 MHz t 88.7 MHz t 88.5 MHz t 88.3 MHz : 88.3 MHz t 88.5 MHz t 88.7 MHz t 88.9 MHz t 89.1 MHz t 89.3 MHz t 89.5 MHz t 89.7 MHz t 89.9 MHz t 88.3 MHz 3 Press (SHUF/REP) for two seconds. Notes • When you change the transmitting frequency on the unit, be sure to tune your FM tuner to the newly selected one. • Press u on the wired remote before changing the frequency if the power to the unit is turned off. With the cut-away portion of the tray facing you, insert the right corner of the tray in the slot, then push in the left corner until it clicks. Note Do not insert the tray upside down or in the wrong direction. 5