Sony CDX-M730 Product Guide / Specifications - Page 1

2002 SONY MOBILE PRODUCT GUIDE CDX-M730 FM/AM Compact Disc Player • Detachable Active Black Panel (ABP) • CD/MD Control w/Custom File™ memory • Hi/Low Pass Filters, F/R/S Preouts • Xplo- d® Power: 52W x 4 • Supplied Wireless Remote (RM-X110) • Optional Wireless Rotary Remote (RM-X6S) • 8fs, 1-Bit D/A Converter • Active Servo Control • 30 Degree Install • CD-RW Playback • 18FM + 12AM memory presets • Dot Matrix, 5-color LCD, clock • Active Display w/Demo Mode • DSO, EQ7 • CD TEXT® • XM Ready • SSIR-EXA Tuner • Indicates step-up Audio Power Specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION 23.2 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion. CD Player Section Signal-to-noise ratio Frequency response Wow and flutter 90 dB 10 – 20,000 Hz Below measurable limit Tuner Section FM Tuning range Antenna terminal Intermediate frequency Usable sensitivity Selectivity Signal-to-noise ratio Harmonic distortion at 1 kHz Separation Frequency response 87.5 – 107.9 MHz External antenna connector 10.7 MHz/450 kHz 8 dBf 75 dB at 400 kHz 66 dB (stereo), 72 dB (mono) 0.6% (stereo), 0.3% (mono) 35 dB at 1 kHz 30 – 15,000 Hz Power Amplifier Section AM Tuning range Antenna terminal Intermediate frequency Sensitivity 530 – 1,710 kHz External antenna connector 10.7 MHz/450 kHz 30 µV Outputs Speaker impedance Maximum power output Speaker outputs 4 – 8 ohms 52 W × 4 (at 4 ohms) General Outputs Inputs Tone controls Loudness Power requirements Dimensions Mounting dimensions Mass Supplied accessories Note Audio outputs (front /rear) Subwoofer output (mono) Power antenna relay control terminal Power amplifier control terminal Telephone ATT control terminal Illumination control terminal BUS control input terminal BUS audio input terminal Antenna input terminal Bass ±10 dB at 62 Hz Treble ±10 dB at 16 kHz +8 dB at 100 Hz +2 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 178 × 50 × 182 mm (7 1/8 × 2 × 7 1/4 in.) (w/h/d) Approx. 182 × 53 × 160 mm (7 1/4 × 2 1/8 × 6 3/8 in.) (w/h/d) Approx. 1.5 kg (2 lb. 10 oz.) Parts for installation and connections (1 set) Front panel case (1) Card remote commander RM-X110 Harness Plug Configuration 12345678 9 10 11 12 13 14 15 16 Plug shown with wires facing viewer. Pin Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Wire Color White Green Purple Gray Blue/white Blue Red Black White/black Green/black Purple/black Gray/black Sky blue Yellow Description Left front + Left rear + Right rear + Right front + AMP Remote ANT Remote Accessory Ground Left front Left rear Right rear Right front ATT Illumination Battery This unit cannot be connected to a digital preamplifier or an equalizer. Design and Specifications subject to change without notice.