Sony CDX-M800 Product Guide / Specifications - Page 1

2003 SONY MOBILE PRODUCT GUIDE CDX-M800 FM/AM Compact Disc Player • (ABP) w/FL Full Motion Display • DSO, EQ7 • CD/MD Control w/Custom File™ memory • XM Ready, CD Text • 52W x 4 High Power • XT-XM1 Control • 8fs, 1-Bit D/A Converter • SSIR-EXA Tuner • Active Servo Control • 60 Degree Install • CD-R/RW Playback • 18FM + 12AM memory presets • Station Memo™, Disc Memo™, Memo List Functions • F/R Preouts w/HPF • Sub Preout w/LPF • Aux Lite Auxiliary Input • Supplied Wireless Card Remote (RM-X110) • Optional Wireless Rotary Remote (RM-X6S) • Indicates step-up Audio Power Specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION 23.2 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion. CD Player Section Signal-to-noise ratio Frequency response Wow and flutter 90 dB 10 – 20,000 Hz Below measurable limit Tuner Section FM Tuning range Antenna terminal Intermediate frequency Usable sensitivity Selectivity Signal-to-noise ratio Harmonic distortion at 1 kHz Separation Frequency response 87.5 – 107.9 MHz External antenna connector 10.7 MHz/450 kHz 9 dBf 75 dB at 400 kHz 67 dB (stereo), 69 dB (mono) 0.5% (stereo), 0.3% (mono) 35 dB at 1 kHz 30 – 15,000 Hz AM Tuning range Antenna terminal Intermediate frequency Sensitivity 530 – 1,710 kHz External antenna connector 10.7 MHz/450 kHz 30 µV Power Amplifier Section Outputs Speaker impedance Maximum power output Speaker outputs (sure seal connectors) 4 – 8 ohms 52 W × 4 (at 4 ohms) General Outputs Inputs Tone controls Loudness Power requirements Dimensions Mounting dimensions Mass Supplied accessories Note Audio outputs (front /rear) Subwoofer output (mono) Power antenna relay control terminal Power amplifier control terminal Telephone ATT control terminal Illumination control terminal BUS control input terminal BUS audio input or AUX IN terminal Antenna input terminal Bass ±10 dB at 62 Hz Treble ±10 dB at 16 kHz +8 dB at 100 Hz +2 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 178 × 50 × 186 mm (7 1/8 × 2 × 7 3/8 in.) (w/h/d) Approx. 182 × 53 × 163 mm (7 1/4 × 2 1/8 × 6 1/2 in.) (w/h/d) Approx. 1.5 kg (2 lb. 10 oz.) Parts for installation and connections (1 set) Card remote commander RM-X110 Harness Plug Configuration 12345678 9 10 11 12 13 14 15 16 Plug shown with wires facing viewer. Pin Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Wire Color White Green Purple Gray Blue/white Blue Red Black White/black Green/black Purple/black Gray/black Sky blue Yellow Description Left front + Left rear + Right rear + Right front + AMP Remote ANT Remote Accessory Ground Left front Left rear Right rear Right front ATT Illumination Battery This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible. Design and Specifications subject to change without notice.