Sony CDX-M8800 Marketing Specifications & diagrams - Page 1

2004 SONY MOBILE PRODUCT GUIDE CDX-M8800 FM/AM Compact Disc Player • Fixed Active Black Panel design • FL ABP Display • MP3 playback • BBE MP • 4-Volt F/R/Sub Preamp output with HPF/LPF • CD/MD control, CD Text • XM Ready • DSO, EQ7 • 52W x 4 high power • Aux Lite auxiliary input • Drive-S • 8fs, 1-bit D/A converter • 45 degree install • CD-R/RW playback • SSIR-EXA tuner, Station Memo • 18FM + 12AM memory presets • Red key illumination • Supplied wireless card remote (RM-X143A) • Optional wireless rotary remote (RM-X6S) • Optional wired rotary remote (RM-X4S) Audio Power Specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION 23.2 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion CD Player Section Signal-to-noise ratio Frequency Response Stereo Separation Total Harmonic Distortion Tuner Section 120 dB 10 - 20,000 Hz 85 dB 0.01% FM Tuning Range Antenna Terminal Intermediate Frequency Usable sensitivity Selectivity Signal-tp-noise ratio Harmonic distortion at 1 kHz Separation Frequency response 87.5 - 107.9 MHz External antenna connector 10.7 MHz/450 kHz 9 dBf 75 dB at 400 kHz 67 dB (stereo), 69 dB (mono) 0.5% (stereo), 0.3% (mono) 35 dB at 1 kHz 30 - 15,000 Hz AM Tuning Range Antenna Terminal Intermediate Frequency Sensitivity 530 - 1,710 kHz External antenna connector 10.7 MHz/450 kHz 30 µV Power Amplifier Section Outputs Speaker impedance Maximum power output Speaker outputs (sure seal connectors) 4 - 8 ohms 52 W x 4 (at 4 ohms) General Preamp Output Level Preamp Impedance Outputs Inputs Tone controls Loudness Power requirements Dimensions Mounting dimensions Mass Supplied accessories Optional accessories 4 Volts 220 ohms Audio outputs (front, rear) Subwoofer output (mono) Power antenna relay control terminal Power amplifier control terminal Telephone ATT control terminal BUS control input terminal or AUX IN terminal BUS audio input terminal Remote controller input terminal Antenna input terminal Bass: ±10 dB at 62 Hz Treble: ±10 dB at 16 kHz +8 dB at 100 Hz, +2 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 178 x 50 x 184 mm (7 1/16 x 2 x 7 1/4 in.) (w/h/d) Approx. 182 x 53 x 162 mm (7 1/4 x 2 1/8 x 6 3/8 in.) (w/h/d) Approx. 1.7 kg (3 lb. 12 oz.) Card remote commander (RM-X143A) Parts for installation and connections Rotary remote commander (RM-X4S) Rotary remote commander (RM-X6S) Harness Plug Configuration 12345678 9 10 11 12 13 14 15 16 Plug shown with wires facing viewer Pin Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Wire Color White Green Purple Gray Blue/white Blue Red Black White/black Green/black Purple/black Bray/black Sky blue Orange/white Yellow Description Left front + Left rear + Right rear + Right front + AMP Remote ANT Remote Accessory Ground Left front Left rear Right rear Right front ATT Illumination Battery Note This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible. Design and Specifications subject to change without notice.