Sony CDX-MP40 Product Guide / Specifications - Page 1

2003 SONY MOBILE PRODUCT GUIDE CDX-MP40 FM/AM Compact Disc Player • MP3 & CD-R/RW Playback • XM Ready • Front & Rear Preouts • XT-XM1Control • Blue 13-segment negative LCD, clock • SSIR-EXA Tuner • Flip-down Detachable Face • 52W x 4 High Power • 8fs, 1-Bit D/A Converter • Active Servo Control • 60 Degree Install • 18FM + 12AM memory presets • CD/MD Control w/Custom File™ memory, CD Text • DSO, EQ3 • Supplied Wireless Card Remote (RM-X115) • Optional Wired Rotary Remote (RM-X4S) • Indicates step-up Audio Power Specifications POWER OUTPUT AND TOTAL HARMONIC DISTORTION 23.2 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 5% total harmonic distortion. CD Player Section Signal-to-noise ratio Frequency response Wow and flutter MS Section 90 dB 10 – 20,000 Hz Below measurable limit FM Tuning range Antenna terminal Intermediate frequency Usable sensitivity Selectivity Signal-to-noise ratio Harmonic distortion at 1 kHz Separation Frequency response 87.5 – 107.9 MHz External antenna connector 10.7 MHz/450kHz 9 dBf 75 dB at 400 kHz 67 dB (stereo), 69 dB (mono) 0.5% (stereo), 0.3% (mono) 33 dB at 1 kHz 30 – 15,000 Hz Power Amplifier Section AM Tuning range Antenna terminal Intermediate frequency Sensitivity 530 – 1,710 kHz External antenna connector 10.7 MHz/450 kHz 30 µV Outputs Speaker impedance Maximum power output Speaker outputs (sure seal connectors) 4 – 8 ohms 52 W × 4 (at 4 ohms) Harness Plug Configuration General Outputs Inputs Tone controls Power requirements Dimensions Mounting dimensions Mass Supplied accessories Note Audio outputs (front/rear) Power antenna relay control terminal Power amplifier control terminal Telephone ATT control terminal Remote controller input terminal BUS control input terminal BUS audio input terminal Antenna input terminal Low: ±10 dB at 60 Hz (XPLOD) Mid: ±10 dB at 1 kHz (XPLOD) High: ±10 dB at 10 kHz (XPLOD) 12 V DC car battery (negative ground) Approx. 178 × 50 × 180 mm (7 1/8 × 2 × 7 1/8 in.) (w/h/d) Approx. 182 × 53 × 161 mm (7 1/4 × 2 1/8 × 6 3/8 in.) (w/h/d) Approx. 1.2 kg (2 lb. 10 oz) Card remote commander RM-X115 Parts for installation and connections Front panel case (1) This unit cannot be connected to a digital preamplifier or an equalizer which is Sony BUS system compatible. 12345678 9 10 11 12 13 14 15 16 Plug shown with wires facing viewer. Pin Number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 Wire Color White Green Purple Gray Blue/white Blue Red Black White/black Green/black Purple/black Gray/black Sky blue Yellow Description Left front + Left rear + Right rear + Right front + AMP Remote ANT Remote Accessory Ground Left front Left rear Right rear Right front ATT Battery Design and Specifications subject to change without notice.