Sony CPD-220VS Operating Instructions (primary manual) - Page 10
Installation
View all Sony CPD-220VS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Installation • Step 1: Connect the computer With the computer switched off, connect the video signal cable to the display (VGA) connector on your computer. If your computer supports the DDC plug-and-play standard, this connection will enable the DDC communication between the display and the computer. Also the video signal cable is combined with audio and microphone cables. If your computer is equipped with sound capability, connect the audio and microphone plugs to appropriate jacks located on your computer. If you use a USB (universal serial bus) device, connect the USB device to the USB downstream jack and the PC to the USB upstream jack. Computer to USB ports sill Blue (to display of connector) Green (to speaker connector) Red (to microphone connector) 0 ®1 to I/Note on handling the video signal cable Do not touch the pins of the video signal cable. I/Note on USB ports USB prots are included to provide state-of-the-art technology. Until USB support is available at the operating system level, you must supply drivers to use USB devices. You can upgrade your operating system to a version that supports USB at the operating system level once a version becomes available. See the manual that came with your USB device for more information on setting it up and using it. 10 Getting Started