Sony CPD-L181 Operating Instructions (primary manual) - Page 6

Getting Started Setup Before using this monitor, check that the following items are included in your carton: • LCD monitor (1) • Rear cover (1) • Power cord (1) • HD15 video signal cable (1) • Macintosh adapter (1) • Windows Monitor Information Disk/Utility Disk (1) • Macintosh Utility Disk (1) • Warranty card (1) • These operating instructions (1) Step 1: Connect the monitor to the computer Turn off the monitor and computer before connecting. Connecting to an IBM PC/AT or compatible computer to -31 or -2 IBM PC/AT or compatible computer to monitor output )410monimenra 11 HD15 video signal cable (supplied) Connecting to a Macintosh Use the supplied Macintosh adapter. to or Macintosh or compatible computer to monitor output )fi 0000 Macintosh adapter (supp ied)* HD15 video signal cable (supplied) • Connect the supplied Macintosh adapter to the computer before connecting the cable. This adapter is compatible with Macintosh LC, Performa, Quadra, Power Macintosh and Power Macintosh G3 series computers (sold before January, 1999). If you are connecting to a Power Macintosh G3 series that sold after January 1999, you will need a different adapter (not supplied). Macintosh II series and some older versions of PowerBook models may need an adapter with micro switches (not supplied). Step 2: Connect the power cord With the monitor and computer switched off, connect one end of the AC power cord to the monitor and the other end to a power outlet. to AC IN If your PC system is not compatible with Plug & Play (DDC2B and DDC2Bi) This monitor uses the No. 9 pin in the video signal connector for Plug & Play (DDC2B and DDC2Bi) compatibility. See page 20 for the location of the No. 9 pin. • If your computer accepts the No. 9 pin, use the supplied HD15 video signal cable. • If your computer does not accept the No. 9 pin, please consult your dealer for advice on obtaining an HD15 adapter. to a power outlet 4INN Power cord (supplied) 6