Sony CPD-L181A Operating Instructions (primary manual) - Page 8
Turning on the Monitor and Computer, Selecting the Input Signal, Press the, switch. - resolution
View all Sony CPD-L181A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Getting Started Turning on the Monitor and Computer 1 Press the u switch. 2 Turn on the computer. The installation of your monitor is complete. If necessary, use the monitor's controls to adjust the picture. If no picture appears on your screen • Check that the monitor is correctly connected to the computer. • If NO INPUT SIGNAL appears on the screen, try changing the input signal, and confirm that your computer's graphics board is completely seated in the correct bus slot. • If you are replacing an old monitor with this model and OUT OF SCAN RANGE appears on the screen, reconnect the old monitor. Then adjust the computer's graphics board so that the horizontal frequency is between 30 - 92 kHz, the vertical frequency is between 40 - 85 Hz, and the resolution is 1280 x 1024 or lower. For more information about the on-screen messages, see "Trouble symptoms and remedies" on page 18. For customers using Windows 95/98 To maximize the potential of your monitor, install the new model information file from the supplied Windows Monitor Information Disk/Utility Disk onto your PC. This monitor complies with the "VESA DDC" Plug & Play standard. If your PC/graphics board complies with DDC, select "Plug & Play Monitor (VESA DDC)" or this monitor's model name as the monitor type in the "Control Panel" of Windows 95/98. If your PC/graphics board has difficulty communicating with this monitor, load the Windows Monitor Information Disk/Utility Disk and select this monitor's model name as the monitor type. For customers using Windows NT4.0 Monitor setup in Windows NT4.0 is different from Windows 95/98 and does not involve the selection of monitor type. Refer to the Windows NT4.0 instruction manual for further details on adjusting the resolution, refresh rate, and number of colors. Adjusting the monitor's resolution and color number Adjust the monitor's resolution and color number by referring to your computer's instruction manual. The color number may vary according to your computer or graphics board. The color palette setting and the actual number of colors are as follows: • High color (16 bit) n 65,536 colors. • True Color (24 bit) n about 16.77 million colors In true color mode (24 bit), speed may be slower. Selecting the Input Signal You can connect two computers to this monitor using the HD 15 connectors. To switch between the two computers, use the ... button. Computers connected to ...2 connected to ...1 Press the ... button. The input signal and corresponding input indicator change each time you press this button. Note If you restart the computer you want to view, or that computer is in power saving mode, the monitor may automatically switch to the other connector's signal. If this happens, manually select the desired signal using the ... button. 8