Sony D-FJ041 Instruction Manual - Page 2

Remaining battery power Bookmark Play mode MONO LOCAL PRESET Band Track number/ Preset number Playing time/Frequency Sound mode * The button has a tactile dot. SOUND/AVLS  (headphones) jack Headphones P MODE/ VOL -/+* OPEN HOLD (rear) Display RADIO ON/ BAND DC IN 4.5 V to an AC outlet AC power adaptor TUNE -/+ *(play/pause)/ ENTER  (stop) • RADIO OFF Power Sources To use the batteries (not supplied) 1 Slide OPEN to open the player lid and open the battery compartment lid inside the CD player. 2 Insert two LR6 (size AA) alkaline batteries by matching the  to the diagram inside the CD player and close the lid until it clicks into place. Insert the  end first (for both batteries). Battery life* (approx. hours) (When the CD player is used on a flat and stable place.) Playing time varies depending on how the CD player is used. G-PROTECTION Two Sony alkaline batteries LR6 (SG) (produced in Japan) G-on G-off RADIO ON 16 11 35 * Measured value by the standard of JEITA (Japan Electronics and Information Technology Industries Association). • The indicator sections of roughly show the remaining battery power. One section does not always indicate one-fourth of the battery power. To use the AC power adaptor Connect the AC power adaptor as illustrated. Playing a CD 1 Slide OPEN to open the lid and fit the CD to the pivot, then close the lid. 2 Press . To play from the first track, press  for 2 seconds or more while the CD player is stopped. • This CD player can play CD-Rs/CD-RWs recorded in the Compact Disc Digital Audio (Audio CD) format, but playback capability may vary depending on the quality of the disc and the condition of the recording device. • This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product. Note on DualDiscs A DualDisc is a two sided disc product which mates DVD recorded material on one side with digital audio material on the other side. However, since the audio material side does not conform to the Compact Disc (CD) standard, playback on this product is not guaranteed. Digital MEGA BASS function During play, press SOUND/AVLS repeatedly to select "SND 1" or "SND 2." If the sound is distorted, turn down the volume. While listening to the radio, this function is disabled. AVLS* function *Automatic Volume Limiter System Press and hold SOUND/AVLS. If "AVLS" flashes three times, the function is enabled. If "AVLS" flashes once, the function is disabled. You can also use this function while listening to the radio. AMS* / search function *Automatic Music Sensor To find the beginning of the previous/current/next/ succeeding track(s): Press / repeatedly. To go backward/forward quickly: Press and hold /. Play mode function During play, press P MODE/ repeatedly: No indication (normal play)  "1"(single track play)  "SHUF"(shuffle play)  " "(Bookmark play) To repeat the play mode you selected, press and hold P MODE/ until " " appears. G-PROTECTION function The function provides protection against sound skipping during many active uses.* The default setting is "G-on." To select "G-off," press  while you keep pressing  during stop. To enjoy high quality CD sound, select "G-off". * Sound may skip: if the CD player receives stronger continuous shock than expected / if a dirty or scratched CD is played / when using poor-quality CD-Rs/CD-RWs or if there is a problem with the recording device or application software. Bookmark play If you add Bookmarks to your favorite tracks, you can listen to these tracks only from the track with the lowest number. 1 During playback of the track where you want to add a Bookmark, press and hold  until " (Bookmark)" flashes on the display. 2 Repeat step 1 to add Bookmarks to the tracks you want. 3 Press P MODE/ repeatedly until " " flashes. 4 Press . To remove the Bookmarks During playback of the track with a Bookmark, press and hold  until " " disappears from the display. If you change CDs and start playing, all the Bookmarks added for the previous CD will be erased. Listening to the Radio 1 Press RADIO ON/BAND to turn on the radio. If "PRESET" appears on the display, press P MODE/ to make "PRESET" disappear from the display. 2 Press RADIO ON/BAND until the band you want appears. Each time you press the button, the display changes as follows:  FM  AM 3 Press TUNE + or - to tune in the station you want and adjust the volume. Turning off the radio Press  • RADIO OFF. Tuning in the station quickly Press and hold TUNE + or - in step 3 until the frequency digits begin to change on the display. The CD player automatically scans the radio frequencies and stops when it finds a clear station. Improving broadcast reception For FM, extend the headphones cord. Headphones For AM, reorient the CD player itself. Note Keep the headphones connected to the  jack of the CD player. The headphones cord works as the FM antenna. If it is hard to hear the FM broadcast due to interference from strong radio waves 1 While listening to the FM broadcast, press SOUND/ AVLS. "LOCAL" flashes. 2 Press /ENTER within 10 seconds after you finished the previous operation.* "LOCAL" stops flashing. * If "LOCAL" disappears from the display, start from Step 1. To cancel the LOCAL setting, press SOUND/AVLS, and then press /ENTER so that "LOCAL" disappears from the display. If it is hard to hear the FM broadcast due to poor reception 1 While listening to the FM broadcast, press SOUND/ AVLS. "LOCAL" flashes. 2 Press SOUND/AVLS again. "MONO" flashes. 3 Press /ENTER within 10 seconds after you finished the previous operation.* "MONO" stops flashing. * If "MONO" disappears from the display, start from Step 1. To cancel the MONO setting, press SOUND/AVLS twice, and then press /ENTER so that "MONO" disappears from the display. Presetting Radio Stations You can preset up to 30 stations: 20 for FM and 10 for AM. 1 While listening to the radio, press P MODE/ to enter the preset mode. "PRESET" appears on the display. 2 Press TUNE + or - repeatedly until the preset number you want appears on the display. 3 Press and hold P MODE/ until "PRESET" flashes on the display. From this step on, start the next operation within 30 seconds after you finished the previous operation. If "PRESET" stops flashing, start from step 3. 4 Press TUNE + or - repeatedly to tune in the station you want. 5 Press /ENTER. To cancel all preset stations 1 While the radio is turned off and CD play is stopped, press RADIO ON/BAND while you are pressing . "CLEAr" flashes. 2 Press /ENTER. Playing Preset Radio Stations 1 Press RADIO ON/BAND to select the band. 2 When "PRESET" does not appear on the display, press P MODE/ to enter the preset mode. "PRESET" appears on the display. 3 Press TUNE + or - to tune in a stored station. Changing the Tuning Interval When using the CD player abroad, change the AM tuning interval, if necessary. 9 kHz area: Asia and Europe 10 kHz area: the U.S.A., Canada and Latin America 1 While the radio is turned off and CD play is stopped, press RADIO ON/BAND while you are pressing . If the current setting is "9 kHz," "10 kHz" flashes on the display. If the current setting is "10 kHz," "9 kHz" flashes on the display. 2 Press /ENTER. Note After changing the tuning interval, you need to preset radio stations again.