Sony DCR-IP220 Network Function Operating Instructions - Page 108
Adjusting the LCD screen (CALIBRATION), Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL
View all Sony DCR-IP220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Troubleshooting Adjusting the LCD screen (CALIBRATION) The buttons on the touch panel may not work correctly. If this happens, follow the procedure below. (1) Set the POWER switch to (CHG) OFF. (2) Eject the tape from your camcorder, then disconnect any connecting cable from your camcorder. (3) Close the LCD panel with the LCD screen facing out. DISPLAY/TOUCH PANEL (4) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL, then keep pressing DISPLAY/TOUCH PANEL for about five seconds. (5) Follow the procedure below with your finger or the supplied stylus. 1 Touch at the upper left corner. 2 Touch at the lower right corner. 3 Touch in the middle of the LCD screen. CALIBRATE CALIBRATE CALIBRATE If you do not press the right spot, always returns to the position at the upper left corner. Note You can only carry out this operation with the LCD screen in the step 3 position. For details on adjusting the LCD screen (CALIBRATION), refer to the operating instructions supplied with your camcorder. 108