Sony DCR-TRV25 PIXELA ImageMixer 1.0 Manual - Page 40
Troubleshooting, Recorded analog sound files jump. analog recording - driver
View all Sony DCR-TRV25 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
2-4-4 Audio CD Recording Mode Troubleshooting Unable to record sound files (analog recording in Windows). (See section 2-4-2) There may be a problem with a driver. There may also be a problem with the connection between the CD drive and the sound card. If you expect this to be the case, contact the relevant manufacturer. Track list not displayed. Confirm that the correct CD drive is selected (Windows only), that the CD currently in the drive is an audio CD, and that the CD drive is functioning properly. Sound files were created, but cannot be played. Check the speaker power and volume. Note that the ImageMixer volume control works independently of the volume control on the speakers. In Windows, right click the speaker icon on the task bar and select 'Open Volume Controls.' If 'CD Audio' is muted or if the volume is too low, adjust accordingly and record again. In Macintosh, open [Apple] menu>[Control Panels]>[Sound], to set the recording sound level. The method for adjusting the volume may be different depending on your computer's configurations, in which case we recommend that you consult the manufacturer's technical support center. Recorded analog sound files contain noise and jump. Check to see whether the volume level is too high. Refer to 'Sound files were created, but cannot be played' above. Also note that we do not recommend that you perform other tasks on your computer while recording is taking place. Recorded analog sound files jump. (analog recording) Your computer hardware may be close to the minimum specifications required to run ImageMixer. Close all other applications before starting ImageMixer and try again. (When the CPU and HDD are not being used to run programs other than ImageMixer, system resources should not become depleted.