Sony DCR-TRV39 Network Function/Application Operating Instructions - Page 140
Messages, General
View all Sony DCR-TRV39 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
Messages Various messages appear on the screen. Check the corresponding descriptions in the following list to correct the problems. General Message USB Connection Error USB Communication Error Cause and/or Corrective Actions A USB device is not connected correctly. c Connect correctly (p. 19). • An invalid USB device is connected. • The connection was interrupted by the USB device. The Connected USB Device is not Compatible Bluetooth Connection Error Bluetooth Authentication Error Check the Certified Status Bluetooth Registration Error Check the Passkey Bluetooth Communication Disconnected Bluetooth Connection Error Select Bluetooth Device PPP Authentication Error Check ID or Password Phone Line Disconnected Connection Error No Response From PPP Server Connection Error Check Phone Line Low Battery Profile Error Reset Profile DI Customer ID Profile Incompleted Unable to Gain IP Address Memory Error An incompatible USB device is connected. • The Bluetooth device is too far from your camcorder. • The Bluetooth device is busy. Register the Bluetooth device again (p. 24). • The entered passkey was not correct. • The passkey transmission failed. • The Bluetooth device is turned off. • The Bluetooth device is too far from your camcorder. • The Bluetooth device is not connectable. No Bluetooth devices are registered. Register the Bluetooth device (p. 24). Your ID or password entered on the PPP screen during manual setup may be wrong (p. 57). Check the connection status. • The telephone number entered on the PPP screen in manual setup may be wrong. • The Modem unit setup on the Network Options screen is wrong. Check that the communication device is connected to the telephone line. The remaining power of the battery pack is not enough. Change the battery pack or use the AC Adaptor. Check the setup. If the settings were cleared, set up again referring to your Setup memo (p. 149). Check your DI customer ID or password entered on the Network Setup screen. IP address is not obtained automatically. The setting may be wrong or the server may be down. Exit the network function, then enter the network function again. 140