Sony DEV3 Operating Guide - Page 42
Additional information, Troubleshooting
View all Sony DEV3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Additional information Troubleshooting If you run into any problems using this product, follow the steps below. Check the list (p. 42 to 43), and inspect this product. Remove the power source, attach the power source again after about 1 minute, and turn this product on. Press RESET (p. 53) using a pointed object, and turn this product on. If you press RESET, all settings, including the clock setting, are reset. Contact your Sony dealer or local authorized Sony service facility. See the Digital Recording Binoculars Handbook (p. 12) for details on the symptoms of this product, and "PMB Help" (p. 37) on connecting this product to a computer. The power does not turn on. Attach a charged battery pack to this product (p. 17). Connect the plug of the AC Adaptor to the wall outlet (wall socket) (p. 20). This product does not operate even when the power is set to on. It takes a few seconds for this product to be ready to shoot after the power is turned on. This is not a malfunction. Disconnect the AC Adaptor from the wall outlet (wall socket) or remove the battery pack, then reconnect it after about 1 minute. If this product still does not work, press RESET (p. 53) using a pointed object. (If you press RESET, all settings, including the clock setting, are reset.) GB 42 The temperature of this product is extremely high. Turn off this product and leave it for a while in a cool place. The temperature of this product is extremely low. Leave this product with the power turned on. If you still cannot operate this product, turn off this product and take it to a warm place. Leave this product there for a while, then turn on this product. This product gets warm. This product may become warm during operation. This is not a malfunction. The power abruptly turns off. Use the AC Adaptor (p. 20). Charge the battery pack (p. 17). Pressing START/STOP or PHOTO does not record images. Press MODE to turn on the (Movie) or (Photo) lamp. This product is recording the image you have just shot on the memory card. You cannot make any new recordings during this period. The memory card is full. Delete unnecessary images. Total number of movie scenes or photos has exceeded the recordable capacity of this product (p. 45). Delete unnecessary images. The recording stops. The temperature of this product is extremely high/low. Turn off this product and leave it for a while in a cool/warm place. "PMB" cannot be installed. Check the computer environment or installation procedure required to install "PMB" (p. 34). "PMB" does not work correctly. Quit "PMB" and restart your computer.