Sony DPP-F700 Read This First - Page 2

Let's print Before printing 1 Remove the stand. Printing 1 1 1 Open the paper tray cover. Hold both sides of the paper tray cover (as shown with arrows) and open it. Inserting the print paper into the paper tray. 5 5 Close the paper tray cover. If you cannot close the tray cover 3  Select an image for printing. 4 Press the / button repeatedly until the image that you want to print appears. Press PRINT. 2 Lay this unit flat (print position) and open  the paper tray compartment door. 3 Tilt the screen up. 3 2 ˎˎYou can put the removed stand in the stand storing space in the back of this unit. ˎˎDo not keep this unit close to cards that may be affected by magnets such as bank cards, credit cards etc. Placing this unit close to a Braun TV may change the colors on the TV screen. 2 2 Make sure the print paper is Stretch out the slide cover, and then close the tray cover. not upside down. Front surface (Printing surface) 3 Rear surface 3 Insert the print paper into the paper tray with the protective sheet facing up. Protective sheet (If there is no protective sheet, insert the print paper into the paper tray with the printing surface (plain white side) facing up.) 4 4 Remove the protective sheet from the tray. You cannot print on a protective sheet. (Doing so may cause a malfunction.) Notes Do not touch the printing surface! Do not cut off from perforated portions! 2  Insert the paper tray and ink ribbon until each clicks into place. Installation place for printing AC adaptor To the wall Install this unit with at least 10 cm outlet (3 13/32 inches) of space at the rear. Power cord 10cm Do not bend! Do not use used print paper! ˎˎ You can use Sony optional color print packs designed for this unit, only. You cannot use the other print packs. For color print packs you can use, refer to the "About the Print Packs" also supplied. ˎˎ You can set up to 20 sheets of print paper. ˎˎ Make sure the print paper is not upside down before printing. Movement of print paper What you can print with this unit Enjoy your printing in a variety of ways Creative Print Pages 55 to 59 in the Operating Instructions Calendar Layout print Batch Print Page 60 in the Operating Instructions Index Print Print All DPOF Print ID Photo The printing process The printer employs a dye sublimation printing system. In this printing system, a thermal print head heats up as it passes over the yellow, magenta and cyan layer of the ink ribbon, causing the dyes to vaporize and permeate the surface of the print paper. A final cycle lays down a laminate layer to protect the printed surface. The direction that the ink film moves inside the ink ribbon Laminate film Cyan Magenta Yellow Print Paper  Notes ˎˎThe ink ribbon cannot be reused. You cannot reuse it by rewinding. ˎˎThe number on the ink ribbon cartridge is the maximum number of sheets that can be printed with that cartridge. (e.g. SVM-F40P means you can print up to 40 sheets.) ˎˎPrint paper emerges from the back and front paper outlets each time a color is printed. Wait until printing is completed and the print paper is automatically ejected onto the paper tray.