Sony FW-55BZ30J Flyer Safety - Page 8
SCREEN For LCD Display only, Broken screen panel For LCD, Display only, SERVICING
View all Sony FW-55BZ30J manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
☐ Do not dispose of batteries in a fire. ☐ Do not short‑circuit, disassemble or overheat the batteries. Warning Batteries must not be exposed to excessive heat such as sunshine, fire or the like or extremely low air pressure that can result in an explosion or leakage of flammable liquid or gas. Caution Risk of explosion if the battery is replaced by an incorrect type. SCREEN (For LCD Display only): ☐ Although the LCD screen is made with high-precision technology and has effective pixels of 99.99% or more, black dots or bright points of light (red, blue, or green) may appear constantly on the LCD screen. This is a structural property of the LCD panel and is not a malfunction. ☐ The LCD screen is made with highprecision technology and to achieve a high level of performance and picture quality, this LCD Display's backlight setting is set to maximize the brightness of the LCD Display. However, uneven brightness may be observed when the LCD Display is viewed in a dark ambient without an input source or with a blank screen. This condition is normal and not a malfunction of the LCD Display. Changing the Picture mode, Backlight setting, enabling the Light Sensor (if applicable), or turning on the Power Management will improve this condition. ☐ To avoid damaging the LCD panel, do not expose the LCD screen to direct sunlight. ☐ Do not push or scratch the LCD screen, or place objects on top of the LCD Display. The images may be uneven or the LCD panel may be damaged. ☐ If the LCD Display is used in a cold place, the picture may smear or become dark. This does not indicate a failure. These phenomena improve as the temperature rises. ☐ Ghosting may occur when still pictures are displayed continuously. It should disappear after a few moments. ☐ The LCD screen and enclosure get warm when the LCD Display is in use. This is not a malfunction. ☐ Avoid spraying insect repellent with volatile material on the LCD screen. ☐ Avoid prolonged contact with rubber or plastic material to the LCD screen. Broken screen panel (For LCD Display only): Do not throw anything at the LCD screen and its edges as the impact can cause the LCD screen glass to crack, break or shatter. ☐ If damage occurs to the LCD panel, small traces of liquid crystal sandwiched between the glass may be found on scattered broken glass. ☐ Do not touch the broken glass with bare hands. As with any broken glass pieces, avoid skin contact and exposure to your eyes or mouth. Avoid direct contact with liquid or damp surfaces of the glass as these may have an adverse effect on some people. The contacted area should be rinsed thoroughly with water. If conditions persist, see your doctor. ☐ If the surface of the LCD Display cracks, do not touch the LCD Display until you have unplugged the AC power cord. Otherwise this may cause an electric shock. SERVICING Do not use the LCD Display if you suspect the LCD Display is damaged or if the LCD Display is damaged. ☐ Do not attempt to service the LCD Display yourself since opening the cabinet may expose you to dangerous voltage levels or other hazards. Refer all servicing to qualified service personnel. ☐ If replacement parts are required, acquire a written certification from the service technician which states that adequate replacement parts with the same or similar characteristics as the original parts have been used. Unauthorized substitutions may result in a fire, an electric shock or other hazards. 8US